Clipsal StarServe - Installation Guide, 11635

SECTION 5Video Distribution - How to ConnectIR Emitter LeadsThe IR emitter leads (or repeaters) are plugged into the modulator. The head of the IR emitter lead is to be fi xed over theIR receiver of the device that is to be remotely controlled with the sticky backing provided on the emitter head.The emitter head will allow the pass through of IR signals from the remote control so the device can operate normallyfrom the room that it is in.8074VMPIRModulatorDeviceTo locate the IR pickup of the device you wish to control, placeyour thumb over the suspected location of the IR pickup.Use the remote control to change channels, fast forward or skip.When you cannot change the status of the device,you are directly over the IR pickup.Note the location and stick the IR emitter lead into position.The IR system will only work when the remotepower switch is in the ON position.INSTALLATION GUIDE47