Clipsal StarServe - Installation Guide, 11635

SECTION 5Video Distribution - How to ConnectSetup of the ModulatorThe back of the modulator has four RCA inputs for active devices such as subscription TV decoders, DVDs, DVRs etc. TheCH refers to the modulator channel input. The input is indicated on the front of the modulator by the letters A – B – C – D.The Modulator is located in the same area as your DVD, subscription TV decoder and video.CBDAUse the UP and DOWNpush buttons to selectthe UHF channel requiredThe screen will indicate theUHF channel the selectedinput will be broadcast onPush select buttonto change fromA, B, C and DSTEP 2 Available channelsSTEPS 1 & 3are UHF 21-69Before you program a UHF channel you must make sure that the UHF frequency is not being used in your region. IfUHF frequencies are being used in your region, you must have at least two-channel separation from the broadcastedchannels. The reason for this is that the signals can spill over to adjacent channels resulting in poor picture qualityfor adjacent channels.Example: SBS is broadcast on UHF 33 - you cannot use channel 32, 33, 34, but you can use channel UHF 35.• Step 1: Select the input CH A, B, C or D you wish to set.• Step 2: Use the up and down push buttons to select the UHF channel you require. The channel will be displayed inthe channel window next to the up and down push buttons.• Step 3: Push the select button again and repeat the process for other input CHs. Your UHF channel has now beenprogrammed. You will need to do an auto search on your TV to tune into these new channels.44 INSTALLATION GUIDE