Download manual

More documents

Recommendations

Info

SYSTEMA S.p.A.SlopeAIRTIGHT GAS-FIRED RADIANT TUBES INFRAIMPORTANTWhen a fairly long drainageduct is made (over 2 mt), adouble curve must be madewith a slope towards the end(see fig. 31); in this way thecondensate that forms onstarting when the plant iscold is deposited in thesiphon; when the plant reachessteady operation, thiscondensate heats up andevaporates.Fig. 316.1.1 Coaxial discharge and intake ducts on the roofAirintake1 2FumesoutletProtectioncapSplitterAirFumes1= Insert the concentric discharge/intake inthe splitter.2= Fix the splitter to the end by means ofthe collar; connect the discharge duct tothe coupling below the splitter (secure itwith the collar) and the intake duct to thecoupling at the side.3= Connect the discharge and intake ductsto the appliance.4= In certain cases there is the possibility ofhanging the splitter on the ceiling withmetal rods or chains.3 4Fig.32 coaxial discharge on the roofRev. 18GB061032
AIRTIGHT GAS-FIRED RADIANT TUBES INFRA6.2 Discharge ducts on the wallSYSTEMA S.p.A.Fig.33 discharge on the wall (the slope towards the outsidefacilitates the exit of any condensate that forms on starting)6.3 Collective dischargeEnvironment air for eliminating condensate phenomenaon the fumes ductFig.34 Collective discharge33Rev. 18GB0610
Page 1 and 2: AIRTIGHT GAS-FIRED RADIANT TUBESINF
Page 3 and 4: AIRTIGHT GAS-FIRED RADIANT TUBES IN
Page 29 and 30: SYSTEMA S.p.A.AIRTIGHT GAS-FIRED RA
Page 31: AIRTIGHT GAS-FIRED RADIANT TUBES IN
Page 49 and 50: SYSTEMA S.p.A.AIRTIGHT GAS-FIRED RA
Page 59: AIRTIGHT GAS-FIRED RADIANT TUBES IN

Download manual

Create successful ePaper yourself

Delete template?

Save as template?