Download manual

AIRTIGHT GAS-FIRED RADIANT TUBES INFRASYSTEMA S.p.A.Fig. 24 Assembling the INFRA module: hood position5) Place the parabolic reflectors on the brackets (after removing the protective film) and join them to each other bylining up the pre-punched holes (fig. 25).6) Fix the parabolic reflectors to each other using the supplied plugs (fig. 25), the first hood must be blocked onto thehood holding bracket (near the burner), using the pin (as shown in fig. 25a); if RBT hoods are used, refer to fig. 1bon page 7.Fig.25 Detail for fixing the hoods27Rev. 18GB0610