Download manual

More documents

Recommendations

Info

SYSTEMA S.p.A.4.2 Assembling the unitAIRTIGHT GAS-FIRED RADIANT TUBES INFRATo assemble the various components that make up theINFRA radiant module, please follow the instructionsgiven below.Begin assembling the tubes, starting with the curvedone:1) Fit the two tubes (delivery and return) into the curveby about 120 mm, hammering slightly if required,taking care to place a piece of wood between thehammer and sleeve (see fig. 18a). Then fix them inplace using the screws supplied with the curve.2a) If Infra 9B and 12B models are used, assemble thetwo sleeves Ø 108mm and Ø80mm, fixing themwith the supplied screws, taking care to push thetubes half way into the sleeve (app. 150 mm), hammeringslightly if required, taking care to place apiece of wood between the hammer and sleeve(see (fig. 18a).2b) If the Infra 6B model is used, assemble the burnerunion and aspirator union as shown in the diagram(fig. 4 page 12), the fixing holes of the aspirator andburner must be positioned vertically as shown in fig.21.3) Fit the other 2 tubes, taking care that the ends withsellotape are positioned at opposite ends to thesleeves (fig. 4 page 12).Fig.17Fig.18WoodFig.18aFig.19Rev. 18GB061024
AIRTIGHT GAS-FIRED RADIANT TUBES INFRASYSTEMA S.p.A.Fig.20HOLEUNIONHOLEBAF BURNERFig. 21 Vertical position of the holeson the aspirator and burner unionsIn Infra 9B a 12B you have to block the pipe 108Ø givingenough space in order to install the Burner Baf lockingFig.21aThe first bracket must be positionedas shown in detail A(fig.23)The intermediate bracketsonly have the bottom elementFig. 22 Assembling the INFRA module: fixing the brackets25Rev. 18GB0610
Page 1 and 2: AIRTIGHT GAS-FIRED RADIANT TUBESINF
Page 3 and 4: AIRTIGHT GAS-FIRED RADIANT TUBES IN
Page 23: AIRTIGHT GAS-FIRED RADIANT TUBES IN
Page 29 and 30: SYSTEMA S.p.A.AIRTIGHT GAS-FIRED RA
Page 49 and 50: SYSTEMA S.p.A.AIRTIGHT GAS-FIRED RA
Page 59: AIRTIGHT GAS-FIRED RADIANT TUBES IN

Download manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?