Foxit PhantomPDF User Manual - Parent Directory

Foxit PhantomPDFUser Manual• Select the Distance Tool to measure the distance between two points. Click the firstpoint, move the pointer to the second point, and click again. The measurements will appearon the page.• Select the Perimeter Tool to measure a set of distance between multiple points. Clickthe first point to start, and then click each point you want to measure. Double-click the lastpoint to end measuring.• Select the Area Tool to measure the area within the line segments that you draw. Clickthe first point to start, and then click each point you want to measure. After you haveclicked at least two points, click the first point or double-click the last point to complete thearea measurement.Note: You can also choose to complete or cancel measurement by right-clicking and choosingoptions from the context menu.After selecting the measuring tool, do any of the following in the pop-up dialog box:• To change the scaling ratio (such as 1:2) on the drawing areas, specify the appropriatenumbers in the tool dialog box. If necessary, change the unit of measurement next to thisratio.• Check Measurement Markup in the tool dialog box if you want the lines you draw to appearas a comment. You can put the pointer over the measurement with the Hand tool selectedso that you can view the measurement and annotation you have drawn.Note: The object you draw will disappear when the Measurement Markup is deselected in theDistance dialog box.Take a look at the following example:A. Select Distance Tool, and set the1 inch =2 inchscale ratio as 1 inch = 2 inch inthe pop-up Distance Tool dialogbox.44