Table of Contents - TG Drives

ECT
resident in the DMC 2 controller.
Stop Halts execution of the application program that is resident
in the DMC 2 controller. CAUTION: STOP does not halt
any on-going motion; only the execution of PL2 code is
halted.
Download Use to download a previously compiled HEX file to the
connected DMC 2 controller. Program name, version and
compiled date are also loaded. The file loaded will be
either the compiled version of the file in the active Edit
Window, or that which was opened by the user.
Note: Any application program in the DMC 2 controller
prior to downloading will be overwritten.
Force Terminal Mode Force controller into terminal mode, in case the controller
was left in computer mode.
Snap Shot Display a snap shot of the current execution state within
the controller.
Unit Select Select the controller (unit address) that will be connected
to the terminal for communication. Up to 15 units can use
the same physical wires, but only one unit can be
connected to the terminal at a time. Note: All connected
units must have unique unit addresses.
Send File For transmitting text files to a controller or an EPROM
programmer.
Test
Capture Records received and transmitted characters in a text file.
The capture file is closed when the terminal window is
closed or when this menu item is activated again. The
status bar indicates the capture file name when the
capture function is active.
EXITING THE TEST ENVIROMENT
To exit the Test environment, close all active windows, saving them as necessary.
User's Manual 5.1 Inmotion Technologies AB
Doc. No.9032 0027 01 (B), Rev. 11.07.2001
217