Table of Contents - TG Drives

ECT
B016
Figure 16. Test Setup window.
Clicking the Setup button in this window displays the window illustrated in
Figure 17 This window is used to establish communications parameters such as
baud rate, port etc.
B017
Figure 17. The communication parameters.
TEST FUNCTION
The user can connect to the DMC 2 controller using different hardware and
communication devices:
• Serial Port.
• CAN network (future).
Test
The communication device is selected using the method described in the previous
section, Test Setup. Once the link is selected, it is active until the test session
terminates. It cannot be changed from within the TEST environment. The selected
communication device is responsible for managing the communications protocol,
User's Manual 5.1 Inmotion Technologies AB
Doc. No.9032 0027 01 (B), Rev. 11.07.2001
215