Table of Contents - TG Drives

EXTENDED REGISTER GROUPS
X7A:6.
In.PTC 11 0..1 R
In.Fault 12 0..1 R
In, Digital inputs
The Out.Fault signal is
binary AND’d with all internal fault
signals and then brought to the Ready relay output.
The result of the binary AND can be read in In.Fault
(Reserved) 13 0..1 R
NIU
(Reserved) 14 0..1 R
NIU
(Reserved) 15 0..1 R
NIU
In.Level 16 0..65535 RW
Bit0 (1) = 0
Bit0 (1) = 1
Sets the active level for each bit of the I/O ports. This variable
can be used to adjust the input logic when an inverting input
buffer board occurs, etc. Normally is not changed.
Bit = 0: Active level is High. Do not invert data from input
(default).
Bit = 1: Active level is Low. Invert data from input.
Active level is High for DI1. Do not invert data from input.
Active level is Low for DI1. Invert data from input.
Bit1 (2) = 0 Active level is High for DI2. Do not invert data from input.
Bit2 (4) = 0 Active level is High for DI3. Do not invert data from input.
Bit1 (8) = 0 Active level is High for DI4. Do not invert data from input.
Bit1 (16) = 0 Active level is High for DI5. Do not invert data from input.
Bit1 (32) = 0 Active level is High for DI6. Do not invert data from input.
Bit1 (64) = 0 Active level is High for DI7. Do not invert data from input.
Bit1 (128) = 0 Active level is High for DI8. Do not invert data from input.
Bit1 (256) = 0 Active level is High for DI9. Do not invert data from input.
Bit1 (512) = 0 Active level is High for DI10. Do not invert data from input.
In.PDI 17 0..4095 R
Parallel read of above I/O ports. Used to read more than one
I/O at a time.
Bit0 corresponds to Di1
Bit1 corresponds to Di2 etc.
b13 (8192) - User output short circuit indication. This bit
indicates that one or several digital outputs are shorted to
ground. (Outputs are short circuit protected).
User's Manual 5.1 Inmotion Technologies AB
Doc. No.9032 0027 01 (B), Rev. 11.07.2001
111