hysol

3.0 TYPICAL CURED PROPERTIES – Values are not intended for use in preparation of specifications.All measurements taken at 25ºC (77ºF) unless otherwise noted. Contact your HYSOL ® representative forinformation regarding specification values.3.1 Cured Physical CharacteristicsRE2039 EE4183 EE1068 TEST/HD0243 /HD0243 /HD0243 METHODColor Amber Tan Black VisualCoefficient of linear thermalexpansion* ASTM D 3386in/in/ºC, (25º to 90ºC), nominal 65 x 10 -6 54 x 10 -6 50 x 10 -6Glass Transition (Tg), ºC, nominal 140 132 98 ASTM D 3386Compressive strength, psi 20-25,000 20-25,000 17-22,000 ASTM D 695Linear Shrinkage, % 0.70 1.38 1.06 ASTM D 2566Filler Content, % 0 40-45 32-37 ASTM D 2584Flammability Pass V-0 UL 94Hardness, Shore D 80-85 80-85 85-90 ASTM D 2240Tensile strength, psi 8-10,000 8-10,000 6-8,000 ASTM D 638Thermal conductivity ASTM D 1674cal x cm/sec cm 2 x ºC 4-5 x 10 -4 11-12 x 10 -4 9-10 x 10 -4Flexural strength, psi 15-20,000 15-20,000 15-20,000 ASTM D 790Moisture absorption ASTM D 750(24 hr immersion), % 0.11 0.13 0.03Guide to operating classIEEE ºC (ºF) 155-180 155-180 155-1803.2 Cured Electrical PropertiesRE2039 EE4183 EE1068 TEST/HD0243 /HD0243 /HD0243 METHODDielectric strength ASTM D 149volts/mil 1,650 1,400 1,200Arc resistance, seconds 110 155 125 ASTM D 495RE2039/HD024325ºC 85ºC 130ºCK D K D K D100 Hz 4.3 .005 4.4 .002 4.4 .0031 kHz 4.3 .009 4.4 .003 4.4 .00310 kHz 4.2 .022 4.4 .004 4.4 .003100 kHz 4.0 .033 4.3 .009 4.4 .002Vol. Res. 1 x 10 17 4 x 10 14 1 x 10 14Surf. Res. 8 x 10 16 4 x 10 15 1 x 10 14