IBM System/7 Functional Characteristics - All about the IBM 1130 ...

Feed Tape and Print0 5 8 11 16 20 26 31Op code R Fun Zeros Mod DA MA00001 XXX 0010000011100010000000001111 II II 1111 III I 1111 11 I 1 1•-......v............,,...., --......N,..■"■....v.■, ,.....,„.....-• ...■•••■■■•• --.......-■-• •-■-.....■"0 8-F 2 0E20 0This command enables the printer and moves the tape to the next character. This characteris printed, and causes an interruption request. The contents of the R field are ignored inthe feed-tape-and-print command.If the operator station motor is not running, condition code 1 is returned and bit 3 ofthe direct control channel status word is set on. Condition code 2 is returned if theoperator station is busy or has an interruption pending.Feed Tape and No Print0 5 8 11 16 20 26 31Op code R Fun Zeros Mod DA MA0 0 0 0 1X XX001 0000011000010000000001111 I 1 11 1111 111 11111 11111•••••■Nr• •-•••■■■•■"0 8-F 2 0 C 2 0 0This command transfers the character under the paper tape pin feed to the operatorstation adapter. The tape is then moved to the next character, and an interruption requestis presented. After the interruption request is presented, a read command must beused to obtain the character from the adapter. The contents of the R field are ignoredin the feed-tape-and-no-print command.If the operator station motor is not running, condition code 1 is returned and bit 3 ofthe direct control channel status word is set on. Condition code 2 is returned if theoperator station is busy or has an interruption pending. This command transfers the firstcharacter sensed from tape into the operator station adapter. Subsequent characters andtape feed cycles are obtained by the read-character-with-tape-feed command alone. Thesequence is stopped by the read-character-without-tape-feed command.