DPSS Laser - 성경 포토닉스

SPMPlusLarge Area Silicon PhotomultiplierSPMPlus Detector SpecificationsTypical Values SPMPlus (Detector) Units Test ConditionsActive Area 1.3 x 1.3 cm 2 -Operating Voltage (typical) 29.5 V +2V above V br , λ = 520nmGain >1x10 6 - -Output Impedance 50 Ω -Number of Microcells 3640 x 16 - TotalPreamplifier Board Gain 2000 V/A Transimpedance Amplifier; 50Ω output loadPhoton Detection Efficiency 10-20 % Range +1V to +4V above V br , λ = 520nmDetailed Specification of Pixel SPMMicro3035X05 - See Datasheet - available on www.SensL.comSPMPlus (Glass Module Specifications)Values SPMPlus (Module) Units CommentsPixel Spacing 3.3 mm Active area to active areaGlass Type White Float glass, High Quality Thin Glass - -Glass Thickness 550 µm Typical ThicknessGlass Transparency >90 % See TX curveGlass Plate Size 20.1x15.5 mm -Board to Board Connector0.5mm Pitch Receptacle - SMT, Dual Row,Vertical Stacking (x70 pin)% See SchematicsFlip-Chip Underfill Low Viscosity Optical Adhesive - -Metal Tracks CrNi -50nm, Ti -100nm, Au -2000nm % -Metal Track Widths Vary Between 150-300 µm -Housing Plastic Housing - See Mechanical DrawingsGeneral SpecificationsParameter Value Units CommentSupply Voltage 1 5 VWith the Power Supply Option this is supplied from the Wall MountedPower Module shipped with the productDetector Bias Voltage 29 ±1 V Not required with Power Supply OptionMax Output Voltage 2 V Per channelMax Storage Temperature 40 °CNote: SensL reserves the right to change all product specification and functionality without notification. Information on this datasheet is believed to be accurate, however, noresponsibility is assumed for any inaccuracies or omissions.Page 2성경포토닉스 91 info@skphotonics