EO18-12003 - toshiba tec europe

8. DIAGNOSTIC TEST OPERATION (C model)EO18-12003(Revision Date: Jun. 21, 2002)8.4 DIAGNOSTIC OPERATION METHOD8.4.13 Drawer TestThe operation of the drawer(s) connected to DRW 1(and 2) of the ST-60 is checked.(1) Select “13. Drawer Test” from the Main Menu by pressing [1] [3], and the [ENTER] key.(2) When the following sub menu is displayed, select “Drawer1 Open” by pressing [1] and the [ENTER]key. Make sure that the drawer connected to DRW1 port is opened. At this time, the status shown in theDrawer Test Sub Menu will be changed as follows:Diagnostic Program===== Drawer Test Menu: =====1.Drawer1 Open2.Drawer2 Open99.ENDNumber ==>Drawer1Drawer2Open CloseWhen the drawer connected to the DRW1 port is closed, the status will be returned to “Drawer1 close”.NOTE: Perform the same test to the Drawer 2.(3) The message “Check OK? [OK:0/NG:9]” appears by pressing [9],[9]. In accordance with the result of thistest, pressing [0] (OK) or [9] (NG) and the [ENTER] key will terminate this test and restore the display to theMain Menu.8.4.14 MEM TestThe operation of the System Memory is checked.(1) Select “14. MEM Test” from the Main Menu by pressing [1] [4], and the [ENTER] key.(2) The result of Memory test will be displayed.***** MEMORY TEST *****START =00100000HEND =0A000000HPATTERM =55555555HMODE =WRITECOMPLETE =0A000000HSUCCESS COUNT = 00000000HERROR(R/W) COUNT = 00000000H ADDR = H DATA= HERROR(PARITY) COUNT = 00000000H ADDR = H(3) Pressing the [ESC] key will terminate this test and restore the display to the Main Menu.8-13