EO18-12003 - toshiba tec europe

7. DIAGNOSTIC TEST OPERATION (A, B models) EO18-12003(Revision Date: Jun. 21, 2002)7.4 DIAGNOSTIC TEST PROCEDURE7.4.12 LAN Test (AMD)The operation of the LAN Controller is checked.NOTE:If the Plug & Play OS is set to [YES] at the BIOS setup, pressing [1] key may restore the display to the“ST-60 Diagnostic Test Program Main Menu”. In this case, select “” from the main menu by pressing [1][2], and [ENTER] key again.(1) Select “LAN Test” from the main menu by pressing [1] [2], and [ENTER] key.LAN Test (AMD) main menu* * * * * * * * * * * * * * * * * * * * * * * * * * * ** ** AMD PCnet(tm) Diagnostic Utility - v2.1 ** Copyright 1996-1997 Advanced Micro Devices, Inc. ** ** * * * * * * * * * * * * * * * * * * * * * * * * * * *Controller I/O Addr PCI Config Addr IRQ Controller Type1 OxFCEO 0x80002800 15 PCnet-PCI IIChoose a controller (q to quit):(2) Pressing [1] key displays the following sub menu.LAN Test (AMD) Sub menuCARD UNDER TESTI/O Addr PCI Config Addr IRQ Controller TypeOxFCEO 0x80002800 15 PCnet-PCI II1. Run Resources Tests2. Run Internal Loopback Tests3. Run External Loopback Tests (Loopback plug is required)4. Run Link Test as SENDER5. Run Link Test as RESPONDER6. Run All Tests7. Goto Main Menu8. Quit ApplicationEnter Highlighted character to Select a test:(3) Make each test by selecting [1] to [3] keys.NOTE:Do not perform the tests of “4. Run Link Test as SENDER”, “5. Run Link Test as RESPONDER”, and“6. Run ALL Tests” which the ST-60 does not support.7-13