EO18-12003 - toshiba tec europe

7. DIAGNOSTIC TEST OPERATION (A, B models) EO18-12003(Revision Date: Jun. 21, 2002)7.4 DIAGNOSTIC TEST PROCEDUREWhen the data in the magnetic card is read normally, the following message will be displayed.***** Card Data Check *****Data Check OK!!Type Any Key!!(3) Pressing any key except [ESC] key while “Type Any Key!!” is shown will display to the following message.1: CONTINVE2: EXITWhen the above message is displayed, pressing [1] and [ENTER] keys will restore the display to “Card ReadTest Display”, and pressing [2] and [ENTER] keys will do to the main menu, respectively.7.4.7 Touch Panel TestThe operation of the touch panel is checked.(1) Select “Touch Panel” from the main menu by pressing [7] and [ENTER] key.(2) When the following sub menu is displayed, select the item. When the Windows 2000 supporting model isused, be sure to select "2: Touch Panel (W2K)".Diagnostic ProgramTouch Panel Test Menu1. Touch Panel2. Touch Panel (W2K)99. ENDINPUT NO.:(3) When the following is displayed, another press of the [ENTER] key will display “Please Push Left-upper pointon the display” which allows you to designate the touch panel active area.Touch Panel Active Area DesignationCOM No. = 4 IRQ No. = 12 Port Address = 2E8h~~~~~~~~~~~~~~~~~~~~~~TTAB.EXE version 1.01NOTE:The displayed values for COM No., IRQ No., and Port Address are initial settings.If the touch panel’s actual operating environment does not match the displayed values, enter the correctvalues for your environment.Use the [→] and [←] keys to select the item to be corrected, and the [↑] and [↓] keys to enter thevalues.7-7