EO18-12003 - toshiba tec europe

7. DIAGNOSTIC TEST OPERATION (A, B models) EO18-12003(Revision Date: Oct. 11, 2005)7.4 DIAGNOSTIC TEST PROCEDURE7.4.5 Drawer TestThe operation of the drawer(s) connected to DRW 1(and 2) of the ST-60 is checked.(1) Select “Drawer” from the main menu by pressing [5] and [ENTER] key.(2) When the following sub menu is displayed, select “Drawer1 Open” by pressing [1] and [ENTER] key. Makesure that the drawer connected to DRW1 port is opened. At this time, the status shown in the Drawer TestSub Menu will be changed as follows:Drawer Test Sub MenuDiagnostic ProgramDrawer Test Menu :1. Drawer1 Open2. Drawer2 Open99. ENDNumber==>Drawer1Drawer2OpenCloseWhen the drawer connecting the DRW1 port is closed, the status will be returned to “Drawer1 close”.NOTE: Perform the same test to the Drawer 2.(3) Pressing [9], [9], and [ENTER] key will terminate this test and restore the display to the main menu.7.4.6 MCR TestThe optional magnetic card reader (MCRST-60-3 Series) is checked.(1) Select “MCR Test” from the main menu by pressing [6] and [ENTER] key.(2) When the following is displayed, pass a magnetic card through the magnetic card reader. Acceptablemagnetic card type: ISO-I Track 1 and 2 typeCard Read Test Display***** CARD READ TEST *****Set Card Reading!!{ Quit }7-6