EO18-12003 - toshiba tec europe

7. DIAGNOSTIC TEST OPERATION (A, B models) EO18-12003(Revision Date: Jun. 21, 2002)7.4 DIAGNOSTIC TEST PROCEDURE7.4 DIAGNOSTIC TEST PROCEDUREInsert the prepared FDK including system file into the FDD of the ST-60. When turning the ST-60 power ON, theST-90’s diagnostic test program will start and the following main menu will be displayed.Selecting and following the displayed procedure will allow each POS I/O device’s operation check. To select themenu, enter the respective number. Pressing [9] twice will terminate the program.ST-60 Diagnostic Test Program Main MenuDiagnostic ProgramMain Menu :1. Speaker Test 13. VGA Test2. LPT1 Test 14. RS Scanner Test3. COM SIO Test 99. END4. UPS Test5. Drawer6. MCR Test7. Touch Pannel8. LIU Test9. RJ Printer Test10. NV RAM Test11. LAN EEPROM Test12. LAN Test (AMD)Number==>_7.4.1 Speaker TestThe operation of the ST-60 built-in speaker is checked.(1) Select “Speaker Test” from the main menu by pressing [1] and [ENTER] key.(2) When “Volume Check” is displayed, press any key of the keyboard. The ST-60's buil-in speaker will beep.(3) Pressing any key again will stop beeping and restore the display to the main menu.7.4.2 LPT1 TestThe connection of the printer (LPT1) is checked.(1) Select “LPT1 Test” from the main menu by pressing [2] and [ENTER] key.(2) The printer connected to LPT1 will print “LPT1 Test Print” on a receipt.7-3