EO18-12003 - toshiba tec europe

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-12003(Revision Date: Mar. 16, 2007)4.5 MEMORY3) Connect the HDD Cable to the Slave HDD (refer to Fig. 4-11), and fix the Bay into the terminal with the fourDSM-3x6 screws (refer to Fig. 4-12). And then attach the PC Card Cover to the original position.DSM-3x6 screwHDD Cable4.5 MEMORYFig. 4-11 DSM-3x6 screwFIg. 4-121) Remove the top cover. (Refer to Section 3.2.1.)2) Install the DIMM memory into the DIMM socket (Refer to Fig.4-13), and then reassemble in the reverse order ofremoval.NOTES:DIMM MemoryDIMM SlotFig. 4-131. The notch on the terminal section of the DIMM memory prevents incorrect insertion. Fit the notchto the projection of the DIMM slot when installing the DIMM memory.2. This terminal is equipped with 8-MB of memory installed on the TOUCH MAIN PC Board as standard,which is expandable up to 72MB (8MB + 64MB DIMM). (A, B models)This terminal is equipped with 64-MB of memory installed on the ST-PGA ENGINE PC Board asstandard, which is expandable up to 320MB (64MB + 256MB DIMM). (C model)3. RoHS-compliant memories below are recommended for the ST-60-C5KEC3-QM-R.Manufacturer Model Name Memory Type No. of Pins Memory SizeCIMA(ELPIDA) C64M6815S-EAT6L1AN SDRAM-DIMM PC133 168 pin 64MBCIMA(SAMUSUNG) C128M6815S-SAT1N SDRAM-DIMM PC133 168 pin 128MBTranscend (SAMSUNG) TS1SND71490E-7SI SDRAM-DIMM PC133 168 pin 128MBCIMA(SAMUSUNG) C256M6815S-SATN SDRAM-DIMM PC133 168 pin 256MBTranscend (SAMSUNG) TS3SND71490E-7SI SDRAM-DIMM PC133 168 pin 256MB4-4