EO18-12003 - toshiba tec europe

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-12003(Revision Date: Jun. 21, 2002)4.3 FDD UNIT (FDDST-60-1-QM)4.3 FDD UNIT (FDDST-60-1-QM)1) Open the FDD connector cover.2) Connect the FDD cable to the following FDD connector (Refer to Fig. 4-3).FDD CableFDD ConnectorFig. 4-34.4 HDD (Hard Disk Drive)Master HDD (A, B, C models)1) Remove the top cover. (Refer to Section 3.2.1)2) Remove the four DSM-3x6 screws to detach the 2.5" HDD holder (Refer to Fig. 4-4).DSM-3x6 Screw2.5” HDD HolderDSM-3x6 ScrewFig. 4-43) Install the HDD unit in the 2.5" HDD holder with the four DSM-3x6 screws (accessory). After that, connectthe HDD cable (accessory) to the HDD.NOTE: Make sure of the direction of the HDD cable when connected to the HDD. (Refer to Fig. 4-5).Slave HDDTo Touch Main PC BoardMaster HDDFig. 4-54-2