EO18-12003 - toshiba tec europe

More documents

Recommendations

Info

3. MAIN UNIT REPLACEMENT EO18-12003(Revision Date: Jun. 21, 2002)3.2 BOTTOM COVER SECTIONC model1) Remove the two DSM-3x8 screws on the bottom of the terminal. (Refer to Fig.3-22)DSM-3x8 screwDSM-3x8 screwFig.3-222) Remove the Touch LVDS Cable from CN4 on the ST-PGA ENGINE PC Board, Earth Plate (refer to Fig. 3-23),and the MCR/HOST cable (when the optional MCR is installed). And then, disconnect the BIU cable from CN14on the ST-PGA ENGINE PC Board (when the customer's display is installed) (refer to Fig. 3-24) and remove theTop Cover by lifting the front side.Touch LVDS Cable Earth Plate CN4MCR/HOST Cable< Front side >Fig. 3-23CN14BIU Unit< Back side >Fig. 3-243-9
3. MAIN UNIT REPLACEMENT EO18-12003(Revision Date: Jun. 21, 2002)3.2 BOTTOM COVER SECTIONNOTES: Caution for attaching the Top Cover1. To protect the worker’s safety, the Top Cover is designed not to close completely so that the Movable Stayhits the shield plate U of the bottom cover. When attaching the Top Cover to the Bottom Cover, close theTop Cover slowly by moving the movable stay in the arrow-indicated direction. (Refer to Fig.3-25).Top CoverBottom CoverMovable StayFig. 3-252. Part of C model contains the Sound Jack PC Board. When attaching the Top Cover to this machine, first fitthe back side of the Top Cover to the hooks of the Bottom Cover, and then attach the Top Cover.As the figure below shows, if the back side of the Top Cover is attached to the hooks of the Bottom Coverincorrectly, the Movable Stay may damage to the Sound Jack PC Board.Top CoverMovable StaySound Jack PC Board3-10
Page 1 and 2: TEC POS TerminalST-60 SERIESMainten
Page 3 and 4: TABLE OF CONTENTSEO18-12003(Revisio
Page 5 and 6: 1. UNPACKING EO18-12003(Revision Da
Page 7 and 8: 2. BEFORE INSTALLATION EO18-120032.
Page 9 and 10: 3. MAIN UNIT REPLACEMENT EO18-12003
Page 15: 3. MAIN UNIT REPLACEMENT EO18-12003
Page 27 and 28: 4. INSTALLATION PROCEDURE FOR OPTIO
Page 43 and 44: 5. ST-60 BIOS SETUP (A, B models) E
Page 57 and 58: 6. ST-60 BIOS SETUP (C model)EO18-1
Page 67 and 68:
6. ST-60 BIOS SETUP (C model)EO18-1
Page 69 and 70:
6. ST-60 BIOS SETUP (C model)EO18-1
Page 71 and 72:
7. DIAGNOSTIC TEST OPERATION (A, B
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
8. DIAGNOSTIC TEST OPERATION (C mod
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107:
10. PERIODICAL MAINTENANCE EO18-120
show all

EO18-12003 - toshiba tec europe

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?