EO18-12003 - toshiba tec europe

8. DIAGNOSTIC TEST OPERATION (C model)EO18-12003(Revision Date: Jun. 21, 2002)8.4 DIAGNOSTIC OPERATION METHOD8.4.20 Touch Panel TestThe operation of the Touch Panel is checked.Before performing the Touch Panel Test, slide the write protection tab of the FDK to the write enable side.(1) Select “20. Touch Panel Test” from the Main Menu by pressing [2] [[0], and the [ENTER] key.(2) When the following sub menu is displayed, select an item. When the Windows ® 2000 supporting modelis used, be sure to select “2. Touch Panel (W2K)”.Diagnostic Program===== Touch Panel Test Menu: =====1. Touch Panel2. Touch Panel (W2K)99. ENDINPUT NO: _(3) When the following is displayed, another press of the [ENTER] key will display “Please Push Left-upperpoint on the display” which allows you to designate the touch panel active area.COM No.= 2 IRQ No.= 3 Port Address = 2F8TTAB.EXE version 1.01NOTE:The displayed values for COM No., IRQ No., and Port Address are initial settings.If the touch panel’s actual operating environment does not match the displayed values, enter the correctvalues for your environment.Use the [→] and [←] keys to select the item to be corrected, and the [↑] and [↓] keys to enter the values.Standard setting: COM No.= 2 IRQ No. = 3 Port Address = 2F8(4) Designate the active area by touching the screen with your finger in order of upper left, upper right, lowerleft, and lower right.(5) When the following display appears, touch any position on the screen with your finger to check that the cursoris displayed where you touched.X = xxxY = xxx[ESC] : Exit[SPACE] : Clear Display[ESC] Key:[SPACE] Key:Terminates this test and restores the display to the main menu.Clears the display. (The touch panel test can be resumed.)(6) Pressing the [ESC] key while the above screen is displayed will restore the display to the Main Menu.8-16