EO18-12003 - toshiba tec europe

8. DIAGNOSTIC TEST OPERATION (C model)EO18-12003(Revision Date: Jun. 21, 2002)8.4 DIAGNOSTIC OPERATION METHOD8.4.17 FDD TestThe operation of the Floppy Disk Drive (FDD) is checked. The Work FDK is required for making this test.(1) Select “17. FDD Test” from the main menu by pressing [1] [7], and the [ENTER] key.As following the instruction on the display, slide the write protection tab of the Work FDK to the writeenable side, and then insert it into the FDD.(2) The result of this test will be displayed.FDD Check is [OK]8.4.18 HDD TestThe operation of the Master Hard Disk Drive is checked.(1) Select “18. HDD Test” from the Main Menu by pressing [1] [8], and the [ENTER] key.(2) The result of this test will be displayed.HDD Check is [OK]8.4.19 RTC SetupThe priority of PXE at booting is set here.(1) Select “19. RTC Setup” from the Main Menu by pressing [1] [9], and the [ENTER] key.(2) When the following sub menu is displayed, select an item.Selecting “1” will set the summary screen enable and set PXE to the top priority at booting.Selecting “2” will restore both settings to the default status.********** Boot Change & Check Sum Write **********1:Summary Enable & PXE Top Priority Boot2:Summary Disable & PXE Default Priority Boot99:ENDINPUT NO.: _(3) Pressing [9], [9], and the [ENTER] key will terminate this test and restore the display to the Main Menu.8-15