7872 Scanner Upgrade to Scanner/Scale
7872 Scanner Upgrade to Scanner/Scale 7872 Scanner Upgrade to Scanner/Scale
7872 Scanner Upgrade to Scanner/ScaleRemove the VIDS Board17988The Video Interface Digital Scale (VIDS) Board mounts to the Optics Tower with twoscrews. All cables and internal harnesses connect to this board.1. Disconnect all cables and internal harnesses from the VIDS Board.• J1 – Speaker• J2 – Interface cable• J5 – Power Supply• J6 – Spinner Motor• J7 – Laser Module Assembly• J8 – RS-232 Peripheral (if present)• J10 – RS-232 Peripheral (if present)• J11 – Checkpoint (if present)2. Remove the two mounting screws.3. Carefully lift the VIDS Board from the unit and place it on an anti-static mat.6 of 2008/01 497-0422375 Release A
7872 Scanner Upgrade to Scanner/ScaleRemove Top Plate Support PostsFour Top Plate Support Posts (with rubber bumpers) are mounted in the FrontSupport. These must be removed since the Top Plate is supported by the H Bar in ascale unit. Be sure to remove the posts as well as the rubber bumpers.Note: Extra force is required to remove the support posts from the Front Supportbecause they are fastened with Locktight.Top Plate Support Postswith Rubber BumpersFront Support19214497-0422375 Release A 08/01 7 of 20
- Page 1 and 2: 7872 Scanner Upgrade toScanner/Scal
- Page 3 and 4: 7872 Scanner Upgrade to Scanner/Sca
- Page 5: 7872 Scanner Upgrade to Scanner/Sca
- Page 9 and 10: 7872 Scanner Upgrade to Scanner/Sca
- Page 11 and 12: 4 1 304 1 304 1 304 1 30U16C15 C16C
- Page 13 and 14: 7872 Scanner Upgrade to Scanner/Sca
- Page 15 and 16: 7872 Scanner Upgrade to Scanner/Sca
- Page 17 and 18: 7872 Scanner Upgrade to Scanner/Sca
- Page 19 and 20: 7872 Scanner Upgrade to Scanner/Sca
<strong>7872</strong> <strong>Scanner</strong> <strong>Upgrade</strong> <strong>to</strong> <strong>Scanner</strong>/<strong>Scale</strong>Remove the VIDS Board17988The Video Interface Digital <strong>Scale</strong> (VIDS) Board mounts <strong>to</strong> the Optics Tower with twoscrews. All cables and internal harnesses connect <strong>to</strong> this board.1. Disconnect all cables and internal harnesses from the VIDS Board.• J1 – Speaker• J2 – Interface cable• J5 – Power Supply• J6 – Spinner Mo<strong>to</strong>r• J7 – Laser Module Assembly• J8 – RS-232 Peripheral (if present)• J10 – RS-232 Peripheral (if present)• J11 – Checkpoint (if present)2. Remove the two mounting screws.3. Carefully lift the VIDS Board from the unit and place it on an anti-static mat.6 of 2008/01 497-0422375 Release A