You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
IMPORTANT To recall other preset<br />
times, press button 6 within 10<br />
seconds.<br />
– press button 5 or 7 to select the<br />
starting time required within 10 seconds.<br />
IMPORTANT Starting time disappears<br />
and the number 3 (corresponding<br />
to the selected preset time) appears<br />
on the display to confirm the<br />
starting time has been entered.<br />
Deleting a programmed<br />
starting time fig. 89<br />
To delete the programmed starting<br />
time, press button 6 briefly: the display<br />
light will go off and number 3 corresponding<br />
to the selected preset<br />
time will disappear.<br />
Recalling a pre-set time fig. 90<br />
Press the button 6 repeatedly until<br />
the required preset starting time appears<br />
on the display (number 3). After<br />
10 seconds, the time will disappear,<br />
number 3 and the display will light up<br />
thus confirming starting time has been<br />
entered.<br />
IMPORTANT To change or delete<br />
pre-set times, follow the instructions<br />
in the paragraphs above.<br />
fig. 90<br />
F0D0135m<br />
Turning the heater off<br />
According to the operation mode<br />
(automatic or manual), the heater can<br />
be turned off:<br />
– automatically, after the preset<br />
period of time (60 minutes when the<br />
display light is red);<br />
– manually by pressing the “heat<br />
now” button on the timer.<br />
In each case, the heater warning light,<br />
the display and the passenger compartment<br />
fan will be turned off and the<br />
heater flame will be blown out.<br />
The coolant circulation pump will<br />
run for approximately two minutes after<br />
the heater has been turned off to<br />
dispose of as much heat as possible.<br />
During this phase the heater can, however,<br />
be turned on.<br />
GETTING TO KNOW YOUR VEHICLE<br />
63