001-104 Ducato MY GB - iinet

To get at the spare wheel:
– remove the two plastic caps Afig.
2;
– unscrew the two bolts C-fig. 2
with the ratchet wrench B and extension
F-fig. 5;
– unscrew the two bolts C-fig. 3 on
the bumper internal side (chassis
cab/truck versions);
fig. 2
fig. 3
F0D0094m
F0D0092m
– release the spare wheel support
with the wrench E-fig. 5 inserted in
seat L-fig. 4 on the left-hand side of
the support and remove the wheel
from under the floor.
Using the ratchet wrench will allow
you to hook and unhook the support
better.
fig. 4
fig. 5
F0D0093m
F0D0091m
3. CHANGING THE WHEEL
1) Loosen the wheel bolts on the
wheel to be changed by approximately
one turn.
2) Turn the ring D-fig. 5 to open
the jack partially.
3) Position the jack near the wheel
to be changed.
4) Alert other passengers that the
vehicle is about to be raised; all persons
should be kept away from the vehicle
until it has been lowered.
5) Fit the extension F-fig. 5 and the
ratchet wrench B on the nut ring and
raise the vehicle until the wheel is a
few inches off the ground. When turning
the jack handle make sure that it
can be used easily and take care not to
scrape your hand against the ground.
IN AN EMERGENCY
139