001-104 Ducato MY GB - iinet

Moving the lever back to position D
the gearbox instantly resumes the automatic
mode selecting the ratio according
to the driving characteristics.
IMPORTANT The electronic control
unit is programmed to change
gear one at a time, therefore repeated
fast actuations will not result in repeated
engagements of the gears. The
higher or lower gear is engaged moving
the lever to the (+) or (–) position
when the previous request has been
performed.
In the event of a fault to the sequential
manual system, the system will select
the automatic mode.
FAILURE INDICATIONS
Automatic gearbox faults are indicated
by the warning light A-fig. 9 on
the instrument panel.
Turning the ignition key to MAR the
warning light should turn on and go
out after about 4 seconds. If the warning
light stays on or if turns on when
travelling, this indicates a gearbox fault
(flashing light) or gearbox oil overheating
(steadily glowing light).
fig. 9
F0D0192m
– Warning light glowing steadily
= automatic gearbox oil maximum
temperature.
If the warning light turns on and
glows steadily when travelling, this indicates
that the gearbox oil has
reached the maximum temperature.
You are therefore advised to stop the
vehicle with the engine at idle speed
and gearshift lever in “N” or “P” (in
this case engine cooling fans are on),
until the warning light goes out and resume
your journey without pushing
the engine to peak performance.
If the warning light turns on again, it
is necessary to stop again with the engine
idling until it goes out.
If there are less than 15 minutes between
one turning on of the warning
light and the next, you are advised to
stop the vehicle, do not switch off the
engine but allow the engine-gearbox
unit to cool down completely (both
engine cooling fans off).
GETTING THE BEST OUT OF YOUR VEHICLE
115