Linear actuator with track roller guidance system and toothed belt ...

More documents

Recommendations

Info

Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94Fitting and mounting of componentsAttaching the toothed beltto the carriage❑ Screw mount the upper and lower clamping pieces of the firstclamping device to the toothed belt:– MLFI25-ZR: M4/2,7 Nm.Figure 25Screw mounting the clampingdevice to the toothed beltFigure 26Screw mounting the clampingdevice to the carriage❑ Screw mount the clamping device to the carriage usingthe adjusting screw:– MLFI25-ZR: M5/5,5 Nm.❑ Screw mount the second clamping device to the toothed belt:– MLFI25-ZR: M4/2,7 Nm.❑ Screw mount the clamping device to the carriage loosely enoughthat the toothed belt is not yet tensioned.00015EDC00015EDBIndustrial Technologies36 MON 73 Schaeffler Group Industrial
Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94Preloading the toothed beltduring refittingPreloading a new toothed beltFigure 27Measurement length marked(not to scale)Figure 28Measurement length preloaded(not to scale)When refitting a toothed belt that has been removed:❑ Reinsert the stored spacer between the clamping deviceand the carriage.❑ Tighten the clamping device with a torque of M5/5,5 Nm tothe hard stop.When fitting a new toothed belt:❑ Mark a measurement length of 1 000 mm on the untensionedtoothed belt.In order to increase the measurement accuracy,themeasurement length can be extended in the case oflonger linear actuators (2 000 mm, 3 000 mm etc.).❑ Tighten the adjusting screw on the second clamping device untilthe measurement length is extended by 1 mm per 1 000 mm.Industrial Technologies00015ED800015ED9Schaeffler Group Industrial MON 73 37
Page 2 and 3: Индастриал Техноло
Page 46: Индастриал Техноло

Linear actuator with track roller guidance system and toothed belt ...

Create successful ePaper yourself

Delete template?

Save as template?