Linear actuator with track roller guidance system and toothed belt ...

More documents

Recommendations

Info

Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94Fitting and mounting of componentsSliding the carriageonto the support rail❑ Slide the carriage carefully onto the raceway shafts.Figure 18Sliding the carriageonto the raceway shafts00015EE0Industrial Technologies30 MON 73 Schaeffler Group Industrial
Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94Setting the profiled track rollersclearance-free❑ Turn the eccentric bolt until the carriage sits without clearance onthe raceway shafts. While doing this, move the carriage by hand.Figure 19Turning the eccentric boltFigure 20Tightening the nuton the eccentric boltNote!Finishing the fitting procedure❑ Tighten the nut of the eccentric bolt to a tightening torqueof 15 Nm. Ensure that the eccentric bolt does not rotate as well.❑ Move the carriage by hand and check whether it can movewithout clearance over the whole length of the support rail.If the carriage cannot move without clearance over the wholelength of the support rail, please contact Application Engineeringat the Linear Technology Division.❑ Press the protective cap into the recess for the eccentric bolt.❑ Drive in the dowel pin on the support rail.00015EF400015EF5Industrial TechnologiesSchaeffler Group Industrial MON 73 31
Page 2 and 3: Индастриал Техноло
Page 46: Индастриал Техноло

Linear actuator with track roller guidance system and toothed belt ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?