Linear actuator with track roller guidance system and toothed belt ...

Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94Carriage A component overview is shown in Figure 14, page 27.The following tools are required:■ torque wrench■ Allen key or hex key inserts■ ring wrench.Damage due to incorrect fitting.❑ Hold the profiled track rollers with the correct fit at the level ofthe raceway shafts.❑ Hold the carriage concentric and parallel to the support rail.❑ Ensure that the carriage runs without clearance over the wholelength of the support rail.❑ After fitting, relubricate the raceway shafts.Fitting the carriage ✓ Drive unit or return unit removed, see page 25.✓ Dowel pin pushed out.Preparing the carriage Protective cap on eccentric boltFigure 16Protective cap on eccentric bolt❑ Remove the black protective cap on the eccentric bolt.1❑ Loosen the nut of the eccentric bolt until the eccentric bolt canbe turned.❑ Turn the profiled track roller of the eccentric bolt towardsthe centre of the carriage.Industrial Technologies00015EE3 Profiled track roller with eccentric boltFigure 17Turning the profiled track rollertowards the centre of the carriage100015EF6Schaeffler Group Industrial MON 73 29