Linear actuator with track roller guidance system and toothed belt ...

More documents

Recommendations

Info

Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94Removal and dismounting of componentsRemoving the toothed belt pulley❑ Remove the snap ring.Figure 13Removing the snap ringDamage to the toothed belt pulley and support rail due tounsuitable tools.❑ Do not use pointed or sharp-edged tools.❑ Do not use a hammer.❑ Remove the toothed belt pulley using a press-out tool.00015EF3Industrial Technologies26 MON 73 Schaeffler Group Industrial
Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94CarriageIt is only necessary to remove the carriage if it is to be replaced bya new carriage.Carriages differ according to the design. However, they are alldismounted in the same way. Hole for relubrication Protective cap for eccentric bolt Profiled track rollers Felt inserts for relubricationFigure 14Overview of carriageDamage due to contaminated lubricant.The characteristics of oil may change due to contamination.❑ The work area must be cleaned before removing the carriage.❑ Elements with oil must be laid only on a clean, lint-free underlay.Removal of carriage ✓ Drive unit or return unit removed, see page 25.Removing the carriage1 24Damage due to incorrect removal.❑ While removing the carriage, hold it concentric and parallel tothe support rail.❑ Push out the dowel pin at the open end of the support rail.❑ Remove the carriage carefully from the support rail.3Industrial Technologies00015EE2Figure 15Removing the carriage00015EDFSchaeffler Group Industrial MON 73 27
Page 2 and 3: Индастриал Техноло
Page 46: Индастриал Техноло

Linear actuator with track roller guidance system and toothed belt ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?