Linear actuator with track roller guidance system and toothed belt ...

Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94CouplingWarningFitting the coupling Hole in the coupling housingFigure 5Screw mounting of the couplingRemoving the couplingThe following tools are required:■ torque wrench■ Allen key or hex key inserts.Sudden start of the machine.Crushing of fingers between the linear actuator and machine parts.❑ Before starting work, disconnect the machine from the powersupply.❑ Secure the main switch of the machine against switching on.✓ Coupling housing fitted.✓ Coupling firmly screw mounted on the motor side to the driveshaft.❑ Slide the coupling onto the drive shaft of the drive unit.There must be a gap of approx. 2 mm left between the couplingand the end face of the housing on the actuator side.❑ Rotate the coupling so that the fixing screw is accessible viathe hole in the coupling housing.❑ Fully tighten the fixing screw. The fixing screw and tighteningtorque will differ according to the coupling used, for informationsee INA publication ALE, Driven Linear Units.1❑ Rotate the coupling so that the fixing screw is accessible viathe hole in the coupling housing.❑ Loosen the fixing screw.❑ Remove the coupling in the direction of the drive shaft.Industrial Technologies00015EE7Schaeffler Group Industrial MON 73 17