Network Camera Server VB101

Initial SetupChecking Operation5Remove the RS-232C path cable connected to the PC usedfor initial setup and connect the LAN cable.When you connect cable, turns off the VB101 power.When you have completed the initial setup, check that the VB101 works normally. Use thesample page to simplify checking.cNoteInstall the Web browser on your PC beforehand.6LANcableHubFollow steps - below to launch the browser and enteryour user name and password.1When you have completed initial setup, launch the Webbrowser and enter the following URL:(Example) http://192.168.100.1/sample/Enter the value specified in the initial settings (→ P.31) as the IP address(192.168.100.1).1 Launch the browser and enter the 3following URL:http://192.168.100.1/admin/2Enter the user name and password.User name: rootPassword: VB101The title page for specify is displayed.A sample page is shown at:http://192.168.100.1/sample/Settings pagecNoteFor the example, the IP address is given as "192.168.100.1". However, the actualIP address must be changed to match your system settings.Sample page3Setup ProcedurescNoteFor the example, the IP address is given as "192.168.100.1". However, the actualIP address must be changed to match your system settings.2Click on the sample page.If the sample page appears and the video image is displayed, the VB101 is operating7Check the operation (→ P.33) and specify detailed settings(→ P.34).normally.cNote● When you change the settings, always you should click the "Send Config.to VB101", or the "Send Config. and Reboot VB101" button.● Before check the operation, install the Web browser on your PC.● To restore the factory initial settings, refer to P.106 in the appendix.32 33