Network Camera Server VB101

VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64mm 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8VC-C4CO MUNICATION CAMERAf:4-64 m 1:1.4-2.8Installation WorkflowInitial SetupOnce the initial setup has been completed and operation has been verified, theVB101 can be used immediately. This section describes the installation procedurefor 3 VB101s and 6 cameras, as shown in the figure below.1Connect the VB101 to the PC tobe used for initial setup byusing bundled RS-232C cable.VB101Installation ExampleCameraCamera2Switch the VB101 and the PC on.The power lamp on the VB101 turns to green. (→ P.18)RS-232C cable tobe used for setupPCCamera3Insert the CD-ROM supplied with the VB101 into the PC andlaunch the "VB101_IP.exe" program.VB101VB101VB101Installation Procedure12Perform initial setup for all the VB101s (→ next page).You should determine the IP address and password for each unit beforehand. Youshould then set these for each VB101 and create the web page before transporting theVB101 to the installation site (→ Chapter 4).Install the VB101 and the cameras. (→ Chapter 2)4Enclosed CD-ROMWhen the "VB101_IP.exe" dialog box appears, use steps toin the procedure below to enter the password, IP address,subnet mask, and gateway address.1 Select the connection port. 2 Switch the VB101 off and then on again.On some PCs youmay have to select aport other than COM1.Check the port numberto which the serialcable is connected.3Setup ProceduresUp to 2 cameras can be controlled.Connect RS-232C cables to controlconnectors CC1 and CC2 on the cameras3 Enter "VB101" as the password4(Factory initial setting).Enter the IP address, subnet mask,and gateway address.to be controlled (→ P.24).3Check the operation. (→ P.33)4Install the remaining VB101 units in the same way and checkthat they are operating normally.30 31cNote● If you do not know the network settings, contact the network administrator.● When you click the [Cancel] button after switching the VB101 back on, thepower LED remains lit orange. At this point, the VB101 software has notstarted up. If you do not need to change the settings, switch the VB101 offand then on again, and check that the power LED turns green. To begin thesetup procedure again, launch "VB101_IP.exe" and then switch the VB101off and on again as directed by the on-screen instructions.