Varian 1200L LC/MS GC/MS - Agilent Technologies

Figure 2 Recommended 1200L GC/MS System LayoutThe 1200L GC/MS system should be installed on a clean, flat surface. The minimum benchspace required for the system is 57 cm x 195 cm, for the CP-3800 GC, 1200MS, and PC;275 cm with the printer. Ensure that the bench is capable of supporting the weight of thesystem: at least 150 kg plus allowances for any options.The foreline pump plugs directly into the MS, and should be positioned on the floor beneath theworkbench on which the 1200 MS system sits. There is a 96 in. (2.44m) vacuum line from theback, left of the MS that connects to the foreline pump.The PC can be positioned either alongside the GC/MS or on a separate table. If a separatetable is chosen, it should be positioned within 10 ft (3m) of the rear of the 1200L.NOTE: See Appendix 1 for exact module specifications.Power Requirements 1200L GC/MSThe 1200L GC/MS system requires one dedicated duplex single-phase power source with earthgrounds hard-wired to the main power panel ground for the gas chromatograph, and a fourplexpower source for the mass spectrometer, computer, and monitor. If you have additional samplepreparation devices or test equipment, we recommend a separate dedicated power source fortheir operation. Never plug the mass spectrometer and the chromatograph into the same powersource; otherwise, you may overload the power source. Never use the free outlet on any of thepower sources for equipment drawing more than 2A.Within North America these power sources must be 20A, 100-115 Vac 60 Hz ±3 Hz.Outside North America, power sources must be 10A, 200-240 Vac, 50 Hz ±3 Hz.03-914961-00:6 7 of 24 1200/1200L MS Pre-installation Instructions