vacuum pump oil msds - CPS Products
vacuum pump oil msds - CPS Products vacuum pump oil msds - CPS Products
Product Name: CPS Pro Set Vacuum Pump OilRevision Date: 10 January 2013Page 4 of 8GHS and other internationalbe cleaned. Practice good housekeeping.ENVIRONMENTAL CONTROLS See Sections 6, 7, 12, 13.SECTION 9 : PHYSICAL & CHEMICAL PROPERTIESTypical physical and chemical properties are given below. Consult the Supplier in Section 1 for additional data.General InformationHEALTH, SAFETY, AND ENVIRONMENTAL INFORMATIONPhysical State Liquid Density at 20C 0.85 - 0.862Color Clear colorless to pale yellow Flash Point typical C (F) >216 (421) See Section 5Odor Characteristic Flammable Limits LEL: N/D UEL: N/DOdor Threshold ND Autoignition Temperature: NDBoiling Point C (F) NDOTHER INFORMATION Vapor Density (Air=1) NDPour Point C (F) -18 (-0 ) or below Vapor Pressure NDFreezing Point ND Evaporation Rate (N-Butyl NDAcetate = 1):Viscosity cSt at 40 o C 46 +/- 10%Solubility in WaterNilOxidizing Properties See Sections 3, 15, 16.SECTION 10 :STABILITY & REACTIVITYSTABILITY:CONDITIONS TO AVOID:MATERIALS TO AVOID:HAZARDOUS DECOMPOSITION PRODUCTS:HAZARDOUS POLYMERIZATION:Material is stable under normal conditions.Excessive heat. High energy sources of ignition.Strong oxidizersMaterial does not decompose at ambient temperatures.Will not occur.SECTION 11: TOXICOLOGICAL INFORMATIONACUTE TOXICITYPotential acute health effectsInhalation: No known significant effects or critical hazards.Ingestion: No known significant effects or critical hazards.Skin contact: No known significant effects or critical hazards.Eye contact: No known significant effects or critical hazards.PRODUCTRoute of ExposureINHALATIONToxicity: LC50 > 5000 mg/m3Irritation: No end point data.INGESTIONToxicity: LD50 > 5000 mg/kgSkinToxicity: LD50 > 5000 mg/kgIrritation: Data available.EyeIrritation: Data available.Conclusion / RemarksMinimally Toxic. Based on test data for structurally similar materials.Negligible hazard at ambient/normal handling temperatures. Based onassessment of the components.Minimally Toxic. Based on test data for structurally similar materials.Minimally Toxic. Based on test data for structurally similar materials.Negligible irritation to skin at ambient temperatures. Based on test data forstructurally similar materials.May cause mild, short-lasting discomfort to eyes. Based on test data forstructurally similar materials.
Product Name: CPS Pro Set Vacuum Pump OilRevision Date: 10 January 2013Page 5 of 8GHS and other internationalCHRONIC/OTHER EFFECTSFor the product itself:Repeated and/or prolonged exposure may cause irritation to the skin, eyes, or respiratory tract.Base oil severely refined: Not carcinogenic in animal studies. Representative material passes IP-346, ModifiedAmes test, and/or other screening tests. Dermal and inhalation studies showed minimal effects; lung nonspecificinfiltration of immune cells, oil deposition and minimal granuloma formation. Not sensitizing in testanimals..CARCINOGENIC EFFECTS:Contains no carcinogens. Similar compounds essentially non-toxic. No component of this product at levels greater than 0.1% isidentified as a carcinogen by ACGIH or the International Agency for Research on Cancer (IARC). No component of this productpresent at levels greater than 0.1% is identified as a carcinogen by the U.S. National Toxicology Program (NTP) or the U.S.Occupational Safety and Health Act (OSHA), NTP or IARC.Although there is no specific test data on all the base oil components, the mineral base oil would not be expected to exhibit carcinogenicpotential based on what is known of the toxicity of mineral base oils in general.The DMSO extract by IP 346 of the oil is less than 3%.(Typical 0.2% with Maximum 0.5%) Consequently it is not classifiedas a carcinogen.The base oil in this product is severely hydro-treated by all hydro-processing route. By this refining history would be showed noevidence of carcinogenic potential.MUTAGENIC EFFECTS: No component of this product at levels greater than 0.1% is classified by established regulatory criteria asa mutagen.TERATOGENIC EFFECTS/DEVELOPMENTAL TOXICITY: No component of this product at levels greater than 0.1% is classified byestablished regulatory criteria as teratogenic or embryotoxic.REPRODUCTION TOXICITY: No component of this product at levels greater than 0.1% is classified by established regulatorycriteria as a reproductive toxin.Additional information is available by request.OVER – EXPOSURE SIGNS/SYMPTOMSSkinIngestionInhalationNo known significant effects or critical hazards.No known significant effects or critical hazards.No known significant effects or critical hazards.SECTION 12 : ECOLOGICAL INFORMATIONThe information given is based on data available for the material, the components of the material, and similar materials.ECOTOXICITYMOBILITYMaterial -- Not expected to be harmful to aquatic organisms.Base oil component -- Low solubility and floats and is expected to migrate from water to the land.Expected to partition to sediment and wastewater solids.PERSISTENCE AND DEGRADABILITYBiodegradation:Base oil component -- Expected to be inherently biodegradableBIOACCUMULATION POTENTIALBase oil component -- Has the potential to bioaccumulate, however metabolism or physical properties may reduce thebioconcentration or limit bioavailability.ECOLOGICAL DATA
- Page 6 and 7: Product Name: CPS Pro Set Vacuum Pu
- Page 8: Product Name: CPS Pro Set Vacuum Pu
Product Name: <strong>CPS</strong> Pro Set Vacuum Pump OilRevision Date: 10 January 2013Page 4 of 8GHS and other internationalbe cleaned. Practice good housekeeping.ENVIRONMENTAL CONTROLS See Sections 6, 7, 12, 13.SECTION 9 : PHYSICAL & CHEMICAL PROPERTIESTypical physical and chemical properties are given below. Consult the Supplier in Section 1 for additional data.General InformationHEALTH, SAFETY, AND ENVIRONMENTAL INFORMATIONPhysical State Liquid Density at 20C 0.85 - 0.862Color Clear colorless to pale yellow Flash Point typical C (F) >216 (421) See Section 5Odor Characteristic Flammable Limits LEL: N/D UEL: N/DOdor Threshold ND Autoignition Temperature: NDB<strong>oil</strong>ing Point C (F) NDOTHER INFORMATION Vapor Density (Air=1) NDPour Point C (F) -18 (-0 ) or below Vapor Pressure NDFreezing Point ND Evaporation Rate (N-Butyl NDAcetate = 1):Viscosity cSt at 40 o C 46 +/- 10%Solubility in WaterNilOxidizing Properties See Sections 3, 15, 16.SECTION 10 :STABILITY & REACTIVITYSTABILITY:CONDITIONS TO AVOID:MATERIALS TO AVOID:HAZARDOUS DECOMPOSITION PRODUCTS:HAZARDOUS POLYMERIZATION:Material is stable under normal conditions.Excessive heat. High energy sources of ignition.Strong oxidizersMaterial does not decompose at ambient temperatures.Will not occur.SECTION 11: TOXICOLOGICAL INFORMATIONACUTE TOXICITYPotential acute health effectsInhalation: No known significant effects or critical hazards.Ingestion: No known significant effects or critical hazards.Skin contact: No known significant effects or critical hazards.Eye contact: No known significant effects or critical hazards.PRODUCTRoute of ExposureINHALATIONToxicity: LC50 > 5000 mg/m3Irritation: No end point data.INGESTIONToxicity: LD50 > 5000 mg/kgSkinToxicity: LD50 > 5000 mg/kgIrritation: Data available.EyeIrritation: Data available.Conclusion / RemarksMinimally Toxic. Based on test data for structurally similar materials.Negligible hazard at ambient/normal handling temperatures. Based onassessment of the components.Minimally Toxic. Based on test data for structurally similar materials.Minimally Toxic. Based on test data for structurally similar materials.Negligible irritation to skin at ambient temperatures. Based on test data forstructurally similar materials.May cause mild, short-lasting discomfort to eyes. Based on test data forstructurally similar materials.
Change language