Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...

More documents

Recommendations

Info

Hardware Connecting the ML605 and FMC-‐150 1. Insert the FMC-‐150 into LPC FMC connector (J63 on the ML605 board as shown in Figure 1). Figure 2 – Inserting the FMC-‐150 board into the ML605 board. Apply slight pressure to ensure proper connection. 7
2. Connect ADC input B and DAC outputs C and D to MMCX to BNC cables as shown below. Inserting these cables requires slight force (you should heard and feel the connection “click” into place. See Figure 2). Figure 3 – Connecting the signal cables to the FMC-‐150. When inserted properly, the reader should feel and hear the cables “click” into place. Inputs A and External Clock are not used in this tutorial. 8
Page 1 and 2: Virtex-‐6 ML605 Development
Page 3: Introduction The purpose of this
Page 10 and 11: 3. Connect a mini-‐B USB ca
Page 12 and 13: Block Diagram Signal Generator Os
Page 14 and 15: 4. Select the top file ML605_fm
Page 17 and 18: 5. After clicking on Configure,
Page 19 and 20: 11. Activate channels one and t
Page 21 and 22: Figure 15 - Removing the origi
Page 23 and 24: 5. When prompted, select yes to
Page 25 and 26: 9. Click next to move on to p
Page 27 and 28: Verification At this point it i
Page 29 and 30: Appendix The appendix of the tu
Page 31 and 32: Designing a Digital LPF in MAT
Page 33 and 34: 7. Use the filter visualization
Page 35 and 36: MATLAB Filter Coefficients % Gen
Page 37: References [1] No author provide

Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...