Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...

More documents

Recommendations

Info

6. Continue to increase the frequency of the function generator beyond the filter cutoff. The amplitude of the filtered signal should fall gradually to zero as the frequency is increased towards the stop frequency (As shown in Figure 23 and Figure 24). Figure 22 -‐ Function generator output at 7Mhz. Figure 23 – Function generator output at 9Mhz. This concludes this part of the tutorial. 27
Appendix The appendix of the tutorial provides the reader <strong>with</strong> additional tutorials and documentation. 28
Page 1 and 2: Virtex-‐6 ML605 Development
Page 3: Introduction The purpose of this
Page 8 and 9: Hardware Connecting the ML605 an
Page 10 and 11: 3. Connect a mini-‐B USB ca
Page 12 and 13: Block Diagram Signal Generator Os
Page 14 and 15: 4. Select the top file ML605_fm
Page 17 and 18: 5. After clicking on Configure,
Page 19 and 20: 11. Activate channels one and t
Page 21 and 22: Figure 15 - Removing the origi
Page 23 and 24: 5. When prompted, select yes to
Page 25 and 26: 9. Click next to move on to p
Page 27: Verification At this point it i
Page 31 and 32: Designing a Digital LPF in MAT
Page 33 and 34: 7. Use the filter visualization
Page 35 and 36: MATLAB Filter Coefficients % Gen
Page 37: References [1] No author provide

Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...

Create successful ePaper yourself

Delete template?

Save as template?

Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...