Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...

More documents

Recommendations

Info

4. Select the top file <strong>ML605</strong>_fmc150 and in the process window (directly below the Design Hierarchy), double click Generate Programming File (As shown in Figure 8). This will synthesize the design producing a bit file. This step takes approximately three minutes to complete. Figure 8 – Select the top module from the Design pane and double click Generate Programming File to generate a bit file and synthesize the design. 13
Running the Design In this part of the tutorial you will program the FPGA <strong>with</strong> the bit file created in the Preparing the Software section. You will then configure ADC channel(s) for optimal performance. Finally you will pass a sine wave into the ADC from the function generator where it will be output by the DAC and viewed on the oscilloscope. 14
Page 1 and 2: Virtex-‐6 ML605 Development
Page 3: Introduction The purpose of this
Page 8 and 9: Hardware Connecting the ML605 an
Page 10 and 11: 3. Connect a mini-‐B USB ca
Page 12 and 13: Block Diagram Signal Generator Os
Page 17 and 18: 5. After clicking on Configure,
Page 19 and 20: 11. Activate channels one and t
Page 21 and 22: Figure 15 - Removing the origi
Page 23 and 24: 5. When prompted, select yes to
Page 25 and 26: 9. Click next to move on to p
Page 27 and 28: Verification At this point it i
Page 29 and 30: Appendix The appendix of the tu
Page 31 and 32: Designing a Digital LPF in MAT
Page 33 and 34: 7. Use the filter visualization
Page 35 and 36: MATLAB Filter Coefficients % Gen
Page 37: References [1] No author provide

Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...