Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...

More documents

Recommendations

Info

Block Diagram Signal Generator Oscilloscope Ch 1 Ch 2 Ch 3 PC USB ML605 Port D JTAG FMC-‐150 Port C Port A PWR Diagram 1 – Block diagram of how to setup should look. 11
Software Before beginning this section ensure that ISE 14.4 is installed and licensed. 1. Unzip the software provided with this tutorial (fmc150_ISE_14_4.zip) to a suitable location (Experience has shown that locations with spaces in the path may cause issues). 2. Launch ISE Design Suite 14.4 3. From the File Menu, select Open Project and locate the ISE project file ‘fmc150_ISE_14_4’ (as shown in Figure X) Figure 6 – Opening the project from ISE. Figure 7 – Open the project from the location of the unzipped contents of the project provided with this tutorial. 12
Page 1 and 2: Virtex-‐6 ML605 Development
Page 3: Introduction The purpose of this
Page 8 and 9: Hardware Connecting the ML605 an
Page 10 and 11: 3. Connect a mini-‐B USB ca
Page 14 and 15: 4. Select the top file ML605_fm
Page 17 and 18: 5. After clicking on Configure,
Page 19 and 20: 11. Activate channels one and t
Page 21 and 22: Figure 15 - Removing the origi
Page 23 and 24: 5. When prompted, select yes to
Page 25 and 26: 9. Click next to move on to p
Page 27 and 28: Verification At this point it i
Page 29 and 30: Appendix The appendix of the tu
Page 31 and 32: Designing a Digital LPF in MAT
Page 33 and 34: 7. Use the filter visualization
Page 35 and 36: MATLAB Filter Coefficients % Gen
Page 37: References [1] No author provide

Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...

Create successful ePaper yourself

Delete template?

Save as template?

Virtex-à¸â6 ML605 Development Board with 4-à¸âDSP FMC-à¸â150 ...