AWS 924-948 - Solid State Logic

Analogue OperationsInsert PointTo switch the channel insert into circuit, press the INS IN switch ( 3 in the pictures on the previous page) in thecentre of the EQ section – the LED to its left lights yellow to indicate that it is active. Press PRE to place the insertimmediately before the EQ in the processing chain.AWS 948When in Stereo channel mode, the insert send and return is stereo. In In-line modes, the left insert connections are usedfor the primary channel path and the right connections for the Monitor path. The active insert is then selected via theChannel Setup screen, described on Page 3-4.Signal Processing OrderThe table below lists the processing order possibilities and the button combinations which accomplish them. The buttonsinvolved are the IP and OP switch in the DYNAMICS area of the meter bridge, and the insert’s PRE switch, locatedabove the INS IN switch mid-way down the EQ section:Processing OrderActive SwitchesEQ ➤ Dynamics ➤ Insert No routing switches activeInsert ➤ EQ ➤ Dynamics PREDynamics ➤ EQ ➤ Insert IPDynamics ➤ Insert ➤ EQ IP + PREEQ ➤ Insert ➤ Dynamics OPInsert ➤ Dynamics ➤ EQ OP + PRE (948)Insert ➤ EQ ➤ Dynamics OP + PRE (924)Page 3-8AWS 924-948 Owner’s Manual