AWS 924-948 - Solid State Logic

More documents

Recommendations

Info

Setup Guide: IO ConfigThe Channel DisplayThe Chan page presents a graphical display all of the controls within the channel.Chan selects thechannel display.Pressing the faderswitch will select achannel to bedisplayed.The large switch above each fader (bottom right-hand corner) refers to the status of the channel’s cut button, andthe smaller switch refers to the solo-isolate function.AWS 948The two fader displays refer to the two channel paths. In Mix In-line mode, the primary channel path is on the left and thesecondary path on the right, regardless of whether or not the fader and V-pot have been swapped. In Track In-line mode,the fader displays are always the other way round.Setting soft switchesA double press on the fader switch (beside the channel fader) will reset all the non-latching switches in the channel strip.These are:• Track bus routing switches• Dynamics assignment and routing switches• Mic/line selection• EQ and Insert IN switches• Aux on/off and EFX reassign switches• REC and MIX bus assignment• Cut switches• Solo Isolate• Fader positionAWS 948In addition:• The V-pot position (see above) • Processing and Aux assignments • CUE• The Return switch and the Channel Mode (In-line Mix, In-line Track or Stereo)If you are confident that all of the soft switches in all of the channels can be reset to the TR position, double-tap on the Allsoftkey.Copying and Swapping settings between channelsStored setups can be copied or swapped between channels by holding down the fader switch on the source channel thenpressing the fader switch on the destination channel. If the Copy soft key is selected the source channel settings arecopied to the destination channel: if not, the source and destination channel settings are swapped.Page 6-6AWS 924-948 Owner’s Manual
Total RecallCentre section displaysCompressor and FoldbackPressing CmFb or pressing themaster fader switch will display thecentre section compressor, the masterfader and foldback sections.A double press on the fader switchwill reset the REC and MIX faderpositions and the REC and MIXprocessing switches.Dynamics and Bus MastersDynB displays themono dynamicssections and the trackand bus masters.Stereo ReturnsStRt displaysthe four stereoreturns.AWS 924-948 Owner’s Manual Page 6-7
Page 1 and 2:
AWS 924-948OWNER’S MANUAL
Page 3 and 4:
IntroductionIMPORTANT INFORMATIONTh
Page 5 and 6:
IntroductionCaution!When installing
Page 7 and 8:
IntroductionMANUAL INDEXØ switch 3
Page 9 and 10:
IntroductionPPAD switch 3-6PAN swit
Page 11 and 12:
IntroductionMANUAL CONTENTSImportan
Page 14 and 15:
IntroductionSECTION 3: ANALOGUE OPE
Page 16 and 17:
IntroductionThe Default Button 4-10
Page 18 and 19:
IntroductionThe Projects Tab 5-5Cop
Page 20 and 21:
IntroductionAPPENDICESSection Conte
Page 22 and 23:
IntroductionKey Features• Combina
Page 24:
AWS InstallationThis page is intent
Page 27 and 28:
Pre InstallationINSTALLATIONPRE-INS
Page 29 and 30:
Pre InstallationUnpacking the Conso
Page 31 and 32:
Studio IntegrationSTUDIO INTEGRATIO
Page 33 and 34:
DAW ConnectionDAW CONNECTIONThe AWS
Page 35 and 36:
DAW Connection• Using an RJ45 cab
Page 37 and 38:
DAW ConnectionDirect Network Connec
Page 39 and 40:
DAW ConnectionSetting Your Workstat
Page 41 and 42:
DAW ConnectionLogic Pro 9When Logic
Page 43 and 44:
DAW ConnectionNetwork Troubleshooti
Page 45 and 46:
DAW ConnectionAssigning the AWS IP
Page 47 and 48:
AWS 924-948OWner’S MAnuAlSeCTIOn
Page 49 and 50:
AWS 924 Tutorial2b - AWS 948 TuTOrI
Page 51 and 52:
AWS 924 TutorialAWS 924 TuTOrIAlStu
Page 53 and 54:
AWS 924 Tutorial924 ChAnnel STrIPIn
Page 55 and 56:
AWS 924 TutorialCenTre SeCTIOnAdjus
Page 57 and 58:
AWS 948 TutorialAWS 948 TuTOrIAlFOC
Page 59 and 60:
AWS 948 TutorialChAnnel MOdeSWhen i
Page 61 and 62:
AWS 948 TutorialAnalogue-style In-l
Page 63:
AWS 948 TutorialAdditional return M
Page 66 and 67:
AWS 948 Tutorialbus routingTo route
Page 68 and 69:
AWS 948 TutorialThis page is intent
Page 70 and 71:
Analogue OperationsThis page is int
Page 72 and 73:
Analogue OperationsMix and Rec Bus
Page 74:
Analogue OperationsThe TFT ScreenTh
Page 78 and 79:
Analogue OperationsInput configurat
Page 80 and 81:
Analogue OperationsInsert PointTo s
Page 82 and 83:
Analogue OperationsDirect OutputBy
Page 84 and 85:
Analogue OperationsScribble StripsC
Page 86 and 87:
Analogue OperationsBus MeterPanelOs
Page 88 and 89:
Analogue OperationsMonitoring1Turn
Page 90 and 91:
Analogue OperationsMonitor InsertTh
Page 92 and 93:
Analogue OperationsMonitor Level Di
Page 94 and 95:
Analogue OperationsDynamics Operati
Page 96 and 97:
Analogue OperationsFoldback Headpho
Page 98 and 99:
Analogue OperationsCommunications S
Page 100 and 101:
Analogue OperationsConsole Setup Me
Page 102 and 103:
Analogue OperationsDAW setupDAW set
Page 104 and 105:
DAW ControlThis page is intentional
Page 106 and 107:
DAW ControlMotion Control Panel 4-1
Page 108 and 109:
DAW ControlThis page is intentional
Page 110 and 111:
DAW ControlFocus ModesIn order to a
Page 112 and 113:
DAW ControlCommunication with your
Page 114 and 115:
DAW ControlSetup GuidelinesWhen mov
Page 116 and 117:
DAW ControlThe Master Control Panel
Page 118 and 119:
DAW ControlSHIFT allows selection o
Page 120 and 121:
DAW ControlChannel Solo and Cut Til
Page 122 and 123:
DAW Control5Select ModeAll 24 chann
Page 124 and 125:
DAW ControlInput, Output and Send R
Page 126 and 127:
DAW Control20Setting Pre and Post R
Page 128 and 129:
DAW Control24Shuttle/Scrub WheelThe
Page 130 and 131:
DAW ControlPlug-In Display ModesThe
Page 132 and 133: DAW ControlThis page is intentional
Page 134 and 135: DAW Control3. Edit Tools MenuEdit T
Page 138 and 139: DAW ControlSuspending AutomationTo
Page 140 and 141: DAW ControlThe majority of DAW func
Page 142 and 143: DAW ControlThe Logic TemplateThe AW
Page 144 and 145: DAW ControlNuendo/Cubase TemplateAs
Page 146 and 147: DAW ControlNuendo Control screenFky
Page 148 and 149: DAW ControlSonar Console LayoutTRAC
Page 150 and 151: DAW ControlDigital Performer Templa
Page 154 and 155: Projects and the RemoteThis page is
Page 160 and 161: Projects and the RemoteOnce a conne
Page 162 and 163: Projects and the RemoteCopying Titl
Page 174 and 175: Total RecallThis page is intentiona
Page 180 and 181: Setup Guide: IO ConfigThis page is
Page 190 and 191: AutomationThis page is intentionall
Page 192 and 193: AutomationThis page is intentionall
Page 194 and 195: Setup Guide: Console ConfigWORKING
Page 196 and 197: AutomationOPERATIONActivating the A
Page 198 and 199: AutomationTo start a mix, press Exe
Page 200 and 201: AutomationJOIN AND REVISEAt any tim
Page 202 and 203: AutomationSELECTING PROTECTIONEach
Page 204 and 205: AutomationAUTOMATION OPTIONSTrimA m
Page 206 and 207: AutomationSnap ModeSnap mode uses t
Page 208 and 209: AutomationFADER LINKSFader Links ar
Page 210 and 211: AutomationTo set up MMC locates, op
Page 212 and 213: AutomationMIDI SYSEX LOADFor legacy
Page 214 and 215: AppendicesThis page is intentionall
Page 218 and 219: AppendicesConsole DimensionsSolid S
Page 222 and 223: C: Connector PinoutsConnector Pinou
Page 230 and 231: G: TroubleshootingAgain for the sak
Page 232 and 233:
G: TroubleshootingThe Channel Strip
Page 234 and 235:
G: TroubleshootingThe Channel Meter
Page 236 and 237:
G: TroubleshootingTroubleshooting C
Page 238 and 239:
AppendicesThis page is intentionall
Page 240 and 241:
AppendicesThis page is intentionall
Page 242 and 243:
J: Block DiagramsJ: BLOCK DIAGRAMSF
show all

AWS 924-948 - Solid State Logic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?