mfturp-1 - SDDC - U.S. Army
mfturp-1 - SDDC - U.S. Army mfturp-1 - SDDC - U.S. Army
TRANSPORTATION SERVICE PROVIDER GENERAL RULESSECTION ATable D of Section E will apply.15 If the rates offered in Table D are to be based on a released value, read Part IV,Section A, Paragraph 14-Released Value in this section, before completing thisitem.16 Place an X in the ―Section E‖ field.§17 Check the ―Less than 10,000 pounds‖ field and/or the ―10,000 pounds orgreater‖ field. This is to designate DoD routing authority only, and will notrestrict the application of less-than-truckload rates or rates above 10,000 pounds.BTSP must enter this publication as the governing publication.E 1 Enter the territorial SPLC codes and locations from which the rates and chargesin Table D will apply.2Enter the territorial SPLC codes and locations to which the rates in Table D willapply.3 If the rates in Table D are to apply between the territorial locations specified inItems 1 and 2, an ―X‖ must be entered in this field.5 Select Rate Qualifier ―PQ‖. Tables A, B, and C may not be used to showpercent of class rates-but alternatively, carrier may select a different RateQualifier (―PH‖ or ―PZ‖) and use Table B to express a rate not related to percentof class rates.6 Table D. All TSP utilizing this table must enter in the ―Minimum Charges‖ fielda percentage above, below, or equal to the baseline minimum charges shown inParagraph 8 of this publication, which they wish to be applied to the movementscovered by the tender. If a TSP is offering rates to apply on movements of FAK(as defined in ITEMS 39, 41, 43, or 45 of Section B, Motor TSP Rules, in thispublication), the percentage above, below, or equal to the level of Class 100baseline rates shown in Paragraph 8 must be entered in the ―Freight All Kinds‖(FAK) field.Section ItemInstructionsTable D. If a TSP is offering rates on specific commodities, the percentageabove, below, or equal to the level of Class 100 baseline rates shown inParagraph 8 must be shown in the ―Specific NMFC or DoD UniqueCommodities‖ field. A TSP may offer rates on FAK and specific commoditiesin the same tender, provided that the codes and descriptions for both FAK andthe specific commodities covered are listed in Item 14, Section A of the tender.F 1-2 TSP using Table D of Section E must enter in the three-character field, the twocharacteralpha codes and sub-items charge number of the security andIssue Date: 29 March 2011 Effective Date: 01 April 2011Military Surface Deployment and Distribution Command1 Soldier WayScott Air Force Base, IL 62225-54-
TRANSPORTATION SERVICE PROVIDER GENERAL RULESSECTION Aaccessorial services which they wish to provide, together with their individuallyestablished charge for each accessorial and security service offered.3. Examples.a. FAK. If a TSP wishes to file percent of class rates applying on all FAK shipmentssubject to a released value of $1.75 per pound per article from, to, and between allpoints in the CONUS, the tender fields would be completed as follows:Section ItemInstructionsA 14 Since FAK is covered by the DoD Unique codes and descriptions shown in themotor section of this publication, the ―DoD Unique‖ field would be checked.Enter ―999912‖ under ―Number‖ column and ―Freight All Kinds‖ or ―FAK‖under the ―Description‖ column, and include the released value as part of thecommodity description.15 Do not make any entry in the RELEASED VALUE box or in the four-positionfield.16 Place an ―X‖ in the ―Section E‖ field.§17 Check both the ―Less than 10,000 pounds‖ and ―10,000 pounds or greater‖fields. This is to designate DoD routing authority, and will not restrict theapplication of either less-than-truckload.BEnter ―MFTURP-1‖ as the governing publication in the fields provided.E 1 Enter ―9C’ in the first two positions of the first field of the SPLC column. Enter―CONUS‖ or Continental U.S.‖ in the first field of the ―LOCATION‖ column.2 Enter ―9C‖ in the first two positions of the first field of the SPLC column. Enter―CONUS‖ or ―Continental U.S.‖ in the first field of the ―LOCATION‖ column.3 Enter an ―X‖ in the BETWEEN field.5 Enter ―PQ‖ (for percent of class) in the RATE QUALIFIER field.Section ItemInstructionsE 6 Table D.―Minimum Charges‖ field: Fill in the field with the appropriate percentage ofthe baseline minimum charges shown in this section. For example, if the TSPwishes to access the same minimum charges shown in this publication, this fieldwould be completed as follows:Minimum Charges: 1 0 0 PercentIf the TSP wished to charge only 80 percent of the baseline minimum chargesshown in this publication, this field would be completed as follows:Issue Date: 29 March 2011 Effective Date: 01 April 2011Military Surface Deployment and Distribution Command1 Soldier WayScott Air Force Base, IL 62225-55-
- Page 3 and 4: SDDC MILITARY FREIGHT TRAFFIC UNIFI
- Page 5 and 6: SDDC MILITARY FREIGHT TRAFFIC UNIFI
- Page 7: TRANSPORTATION SERVICE PROVIDER GEN
- Page 10: TRANSPORTATION SERVICE PROVIDER GEN
- Page 13 and 14: TRANSPORTATION SERVICE PROVIDER GEN
- Page 15 and 16: TRANSPORTATION SERVICE PROVIDER GEN
- Page 17 and 18: TRANSPORTATION SERVICE PROVIDER GEN
- Page 19 and 20: TRANSPORTATION SERVICE PROVIDER GEN
- Page 21 and 22: TRANSPORTATION SERVICE PROVIDER GEN
- Page 23 and 24: TRANSPORTATION SERVICE PROVIDER GEN
- Page 25 and 26: TRANSPORTATION SERVICE PROVIDER GEN
- Page 27 and 28: TRANSPORTATION SERVICE PROVIDER GEN
- Page 29 and 30: TRANSPORTATION SERVICE PROVIDER GEN
- Page 31 and 32: TRANSPORTATION SERVICE PROVIDER GEN
- Page 33 and 34: TRANSPORTATION SERVICE PROVIDER GEN
- Page 35 and 36: Part V - Rate SectionsTRANSPORTATIO
- Page 37 and 38: TRANSPORTATION SERVICE PROVIDER GEN
- Page 39 and 40: TRANSPORTATION SERVICE PROVIDER GEN
- Page 41 and 42: TRANSPORTATION SERVICE PROVIDER GEN
- Page 43 and 44: TABLE ATRANSPORTATION SERVICE PROVI
- Page 45 and 46: TRANSPORTATION SERVICE PROVIDER GEN
- Page 47 and 48: TRANSPORTATION SERVICE PROVIDER GEN
- Page 49 and 50: TRANSPORTATION SERVICE PROVIDER GEN
- Page 51 and 52: TRANSPORTATION SERVICE PROVIDER GEN
- Page 53: TRANSPORTATION SERVICE PROVIDER GEN
- Page 57 and 58: TRANSPORTATION SERVICE PROVIDER GEN
- Page 59 and 60: TRANSPORTATION SERVICE PROVIDER GEN
- Page 61 and 62: TRANSPORTATION SERVICE PROVIDER GEN
- Page 63 and 64: TRANSPORTATION SERVICE PROVIDER GEN
- Page 65 and 66: TRANSPORTATION SERVICE PROVIDER GEN
- Page 67 and 68: TRANSPORTATION SERVICE PROVIDER GEN
- Page 69 and 70: TRANSPORTATION SERVICE PROVIDER GEN
- Page 71 and 72: TRANSPORTATION SERVICE PROVIDER GEN
- Page 73 and 74: TRANSPORTATION SERVICE PROVIDER GEN
- Page 75 and 76: TRANSPORTATION SERVICE PROVIDER GEN
- Page 77 and 78: TRANSPORTATION SERVICE PROVIDER GEN
- Page 79 and 80: MOTOR TRANSPORTATION SERVICE PROVID
- Page 81 and 82: MOTOR TRANSPORTATION SERVICE PROVID
- Page 83 and 84: MOTOR TRANSPORTATION SERVICE PROVID
- Page 85 and 86: MOTOR TRANSPORTATION SERVICE PROVID
- Page 87 and 88: MOTOR TRANSPORTATION SERVICE PROVID
- Page 89 and 90: MOTOR TRANSPORTATION SERVICE PROVID
- Page 91 and 92: MOTOR TRANSPORTATION SERVICE PROVID
- Page 93 and 94: MOTOR TRANSPORTATION SERVICE PROVID
- Page 95 and 96: MOTOR TRANSPORTATION SERVICE PROVID
- Page 97 and 98: MOTOR TRANSPORTATION SERVICE PROVID
- Page 99 and 100: MOTOR TRANSPORTATION SERVICE PROVID
- Page 101 and 102: MOTOR TRANSPORTATION SERVICE PROVID
- Page 103 and 104: MOTOR TRANSPORTATION SERVICE PROVID
TRANSPORTATION SERVICE PROVIDER GENERAL RULESSECTION Aaccessorial services which they wish to provide, together with their individuallyestablished charge for each accessorial and security service offered.3. Examples.a. FAK. If a TSP wishes to file percent of class rates applying on all FAK shipmentssubject to a released value of $1.75 per pound per article from, to, and between allpoints in the CONUS, the tender fields would be completed as follows:Section ItemInstructionsA 14 Since FAK is covered by the DoD Unique codes and descriptions shown in themotor section of this publication, the ―DoD Unique‖ field would be checked.Enter ―999912‖ under ―Number‖ column and ―Freight All Kinds‖ or ―FAK‖under the ―Description‖ column, and include the released value as part of thecommodity description.15 Do not make any entry in the RELEASED VALUE box or in the four-positionfield.16 Place an ―X‖ in the ―Section E‖ field.§17 Check both the ―Less than 10,000 pounds‖ and ―10,000 pounds or greater‖fields. This is to designate DoD routing authority, and will not restrict theapplication of either less-than-truckload.BEnter ―MFTURP-1‖ as the governing publication in the fields provided.E 1 Enter ―9C’ in the first two positions of the first field of the SPLC column. Enter―CONUS‖ or Continental U.S.‖ in the first field of the ―LOCATION‖ column.2 Enter ―9C‖ in the first two positions of the first field of the SPLC column. Enter―CONUS‖ or ―Continental U.S.‖ in the first field of the ―LOCATION‖ column.3 Enter an ―X‖ in the BETWEEN field.5 Enter ―PQ‖ (for percent of class) in the RATE QUALIFIER field.Section ItemInstructionsE 6 Table D.―Minimum Charges‖ field: Fill in the field with the appropriate percentage ofthe baseline minimum charges shown in this section. For example, if the TSPwishes to access the same minimum charges shown in this publication, this fieldwould be completed as follows:Minimum Charges: 1 0 0 PercentIf the TSP wished to charge only 80 percent of the baseline minimum chargesshown in this publication, this field would be completed as follows:Issue Date: 29 March 2011 Effective Date: 01 April 2011Military Surface Deployment and Distribution Command1 Soldier WayScott Air Force Base, IL 62225-55-