11.07.2015 Views

mfturp-1 - SDDC - U.S. Army

mfturp-1 - SDDC - U.S. Army

mfturp-1 - SDDC - U.S. Army

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

TRANSPORTATION SERVICE PROVIDER GENERAL RULESSECTION A500 miles (distant bracket 451-500), the computation will be: 43,231 pounds/100 = 432.31cwt units, 432.31 cwt units x 1.50 = $648.47 charge.5. Minimum weight, gallon or mileage columns will not be altered. TSP are free to providerates for any or all minimums, limited only by their ability to perform. TSP must ensurerates are provided in every field, from the lowest to the highest mileage bracket, coveredin tender’s territorial application. For example, if service is offered from VA to MD, themileage bracket reflecting the maximum possible distance between points in these twostates must be completed. Rates must be included for the same minimum columns on eachmileage line used. Per hundredweight rates cannot be stated in fractions of cents.6. Rail TSP may offer incentive rates when using Rate Qualifiers PH, PZ, PY or PG.Incentive rates will apply to freight loaded in the same rail car and will be applicable toany weight/gallon greater than the highest minimum weight/gallon shown in the Table.Rates must be lower than rate applicable to highest minimum weight/gallon shown.TABLE FThis table will only be used for dromedary service expressed on a territorial basis. Offeringdromedary service, rates, and minimum weights (i.e., Regular and 410 Dromedary Service)will be as indicated in Section D. No change to mileage is permitted. Procedures forcomputing charges for Rate Qualifier DZ is explained in Paragraph 5 in this Section must befollowed. TSP must ensure rates or charges are provided in every field, from lowest tohighest mileage bracket, to the extent of the tender's territorial application. For example, ifservice is offered under this Table from PA to MD, mileage reflecting the maximum possibledistance between points in these two states must be completed. Rates must be included forsame minimum columns on each mileage line used.Section E-1 State To State Rate Matrix (Interstate only)1. This section contains a matrix for expressing rates, from and to states and/or state zones.Rates will only apply from Origins listed in the ―FROM‖ portion across the top, todestinations listed in the ―TO‖ portion along the left hand side.2. Only rates for PM and PZ may be used in Section E-1. Indicate in the space providedwhether PM or PZ (see item 5 below) is being used. Only rates for PZ may be expressed asa fraction of a cent. The procedure for computing PZ charges is explained in Section E,Paragraph 5.a of these instructions and must be followed.3. Minimum charge may be indicated in field provided. Only one minimum charge per tenderwill be allowed.Issue Date: 29 March 2011 Effective Date: 01 April 2011Military Surface Deployment and Distribution Command1 Soldier WayScott Air Force Base, IL 62225-45-

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!