ToneLab Owner's Manual - Vox

4. PHASERA model of a much respected and popular analogue phaser, housed in a bananayellow box![1] “SPEED” 0.100...10.00 [Hz](EX) Adjusts the modulation speed.[2] “RESO(RESONANCE)” 0.0...10.0 Adjusts the amount of resonance.[3] “DEPTH” 0.0...10.0 Adjusts the modulation depth.(*) MANUAL 1.0...10.0 Adjusts the center frequency of thesweep.5. TREMOLOThis effect is based on the highly acclaimed tremolo circuit found in a BLACK2x12.The SPREAD setting lets you create panning effects that are spread to leftand right.[1] “SPEED” 1.00...10.00 [Hz](EX) Adjusts the tremolo speed.[2] “SPREAD”0.0...10.0 Adjusts the left/right spaciousness.[3] “DEPTH” 0.0...10.0 Adjusts the tremolo depth.6. ROTARYThis models a stereo rotary speaker.When you adjust the SPEED control of the ROTARY effect (either via thefront panel or the optional foot controller) the effect takes awhile to reach the specifiedspeed - just like a real rotating speaker. Why? Because, in the real world, ittakes a second or two for the motor controlling the speaker rotation to speed up orslow down! (You can use TIME to adjust the length of this transition.)[1] “SPEED” 0.80...10.00 [Hz](EX) Adjusts the rotational speed of the speaker.[2] “TIME” 1.0...10.0 Adjusts the time required for the rotationalspeed to change.[3] “DEPTH” 0.0...10.0 Adjusts the modulation depth.E. DELAY EFFECTSHere you can make settings for a delay effect inserted after the cabinet. You canchoose one of three (3) distinctly different delay effects. In all three cases, themaximum delay time possible is two seconds.(EX): This indicates a parameter that you can control from the expression pedalof the optional foot controller.(*): This indicates a parameter that you can set when using the Sound Editor.These parameters cannot be edited when using ToneLab alone.DELAY FINE: knob 1 MIX: knob 2 FEEDBACK: knob 3DELAY/TAPE ECHO/MULTI HEAD “TIME” 0...2000 [ms] “MIX” 0.0...10 “FEEDBACK” 0.0...1038