ToneLab Owner's Manual - Vox

SetupNOTE: You MUST turn off the power of all your equipment before you make connections.If you ignore this warning, you may damage your speaker system orexperience malfunctions!BASIC CONNECTIONS1. Use audio cables to connect the ToneLab’s OUTPUT L/MONO (9.2) to yourmixer/recorder or guitar amp. (p.13, 14)NOTE: If you’re making connections in mono, use the OUTPUT L/MONO jack.However to take the fullest advantage of ToneLab’s sound, we strongly recommendthat you use stereo connections.If you are using headphones, plug them into the PHONES jack (5.2).NOTE: Signal from the OUTPUT jack will still be heard even if headphones areplugged in.If you want to use an optical cable to connect ToneLab to a digital mixer orrecorder, connect the cable to the S/P DIF OUT jack (9.4). (p.13)2. If you connect ToneLab to a mixer or recorder, set the AMP/LINE switch (9.1)to “LINE.” If you connect it to a guitar amp, set the switch to “AMP.”3. Turn the LEVEL knob (9.3) located on the rear of ToneLab all the way towardthe left (as seen from the rear), setting the volume to 0.4. Connect the included AC/AC power supply to the rear panel AC9V power supplyjack (6.1), and then connect the plug to an AC outlet.5. Plug your guitar into the INPUT jack (5.1).6. First, turn down the volume of your amp or mixer so you don’t hear crackles orpops when the power is turned on! Then turn on the STANDBY switch (6.2) toturn on the power.7. Adjust the volume by using the controls of your amp or mixer, and ToneLab’srear panel LEVEL knob (9.3).To a mixer/recorderor guitar ampLINE/AMPTo a digitalmixer/recorderS/P DIF OUTDedicated foot controllerVOX BUSGuitarOUTPUTL/MONORTo a MIDI sequenceror computer~AC9VAC/AC powersupplyTo an ACoutletHeadphonesPHONESToneLabMono jackINPUT12