GearBoss Shelving System - Wenger Corporation

More documents

Recommendations

Info

INSTALLATION CONTINUEDINSTALLING THE SHELF SUPPORT BRACKET9. To determine the location of the shelf support bracket, placethe upright tube onto the tube support bracket and position uprightagainst the wall.10. Using the marking tool plate, mark the wall at the bottom edge of themarking tool plate (Detail B).11. Continue previous step until all upright tubes have beenmarked.MARKHEREDetail B12. Snap a chalk line across the two highest marks.Note: If there is more than 1” discrepancy between the chalk line and the lowest mark, contact<strong>Wenger</strong> <strong>Corporation</strong> for further instructions.Note: If the wall is stud construction, mark the location of each stud along the chalk line.Stud LocationsChalk LineWallFloor8
INSTALLATION (CONTINUED)INSTALLING THE SHELF SUPPORT BRACKET (CONTINUED)13. Place the first upright tube on it’s support bracket. Using a level to keep the upright tubevertical, make a V-mark on the chalk line 1 1/4” to the left of the upright tube.1 1/4”Chalk LineV-MarkUpright TubeWallRemove the upright tube from it’s support bracket.14. Hold the shelf support bracket with it’s bottom edge on the chalk line and it’s left end atthe V-mark.If the wall is masonry construction, locate the first shelf support bracket here, referring tothe fastener guidelines on page 4.If the wall is stud construction, it may be necessary to (1) move the shelf support bracketto the left until the punched holes align with the studs or (2) drill holes in the shelfsupport bracket to align with the studs.Warning: With stud wall construction, a fastener must be installed in every stud. Refer tothe fastener guidelines on page 4.Chalk LineMove shelf support bracket if necessary.V-MarkFastenersShelf Support BracketEach additional shelf support bracket must overlap the previous one so the end holesalign. If the last shelf support bracket is too long, it may be cut off 1” past the last uprighttube.Shelf Support BracketOverlap & Align Holes9
Page 2 and 3: SAFETYThroughout this manual you wi
Page 4 and 5: REQUIRED TOOLSThe following tools m
Page 6 and 7: DESCRIPTIONGEARBOSS SHELVING SYSTEM
Page 10 and 11: INSTALLATION (CONTINUED)INSTALLING

GearBoss Shelving System - Wenger Corporation

Create successful ePaper yourself

Delete template?

Save as template?