GearBoss Shelving System - Wenger Corporation

More documents

Recommendations

Info

REQUIRED TOOLSThe following tools must be supplied by the installer to assemble the GearBoss shelving system.Phillips Drive BitCombination WrenchClampCordless DrillNumber 2B PencilLevelTape Rule50-foot Chalk LineMalletFASTENERSBecause materials and construction of floors and walls can vary, fasteners for attaching the GearBossshelving system to the structure are not provided. The installer must choose the appropriate fastenerand follow the manufacturer’s directions.Warning: Inferior or improperly installed fasteners could cause sudden collapse of the GearBossshelving system. Serious injury or damage to property may result.GearBoss shelving system fastener guidelines:• If the floor is wood construction, attachment should be by sheet metal or lag screws (#10minimum).• Ιf the floor is concrete, attachment should be by Concrete screw (Tapcon), or sheet metal screws(#10 minimum) into metal or plastic inserts.• Ιf the wall is wood stud-and-drywall construction, attachment should be by lag screws (1/4”minimum) into every stud.• Ιf the wall is metal stud-and-drywall construction, attachment should be by toggle bolt (1/4”minimum) into every stud.• Ιf the wall is concrete block construction, attachment should be by Concrete screw (Tapcon) ortoggle bolt (1/4” minimum), spaced no more than 16” apart.• Ιf the wall is poured concrete construction, attachment should be by Concrete screw (Tapcon) orwedge-type concrete anchors, spaced no more than 24” apart.Note:Each wall connection must be rated for a minimum of 500 lbs tension. Other fasteners may beappropriate if the tension requirement is met.4
PARTS LIST12312413591410768Item Description Item Description1 Upright Tube, 8’ 10 Marking tool Plate2 Shelf Support Bracket 11 Screw, Drill/Tap, 1/4-14 X 3/4 (not shown)3 Tube Support Bracket 12 Cap-screw, 3/8-16 X 2 3/44 48” Shelf Tube 13 Divider Wing Nut, 3/8-165 Shelf Bracket, 30 1/2”, RH 14 Shelf Plug Half6 Shelf Bracket, 30 1/2”, LH 15 Carriage Bolt, 1/4-20 X 1 1/4 (not shown)7 Shelf Bracket, 17 1/2”, RH 16 Carriage Bolt, 1/4-20 X 2 1/2 (not shown)8 Shelf Bracket, 17 1/2”, LH 17 Wing Nut, 1/4-20 (not shown)9 Shelf Extrusion Assembly5
Page 2 and 3: SAFETYThroughout this manual you wi
Page 6 and 7: DESCRIPTIONGEARBOSS SHELVING SYSTEM
Page 8 and 9: INSTALLATION CONTINUEDINSTALLING TH
Page 10 and 11: INSTALLATION (CONTINUED)INSTALLING

GearBoss Shelving System - Wenger Corporation

Create successful ePaper yourself

Delete template?

Save as template?