GearBoss Shelving System - Wenger Corporation

SHELF ASSEMBLY/INSTALLATIONTo Assemble the shelf:21. Determine the desired location of the shelf on the upright tube.22. Position the shelf bracket on the inside of the upright tube.23. Insert the cap-screw (item 12) through the upright tube and shelf bracket, and secure it using thedivider wing nut (item 13).24. Repeat on the opposite upright tube. Make sure the shelf brackets are even, to ensure a level shelf.The best way to determine the exact location is to count the number of holes in the upright tube.25. Line up the shelf extrusion assembly to the end of the shelf brackets. Lightly tap the shelf extrusionassembly ends with a mallet until they snap into place. Make sure the shelf extrusion assembly tabis locked into place on the shelf bracket. (Detail E)26. Using carriage bolt (item 15) and wing nut (item 17), fasten the shelf extrusion assembly to the shelfbracket. (Detail F)Note: If shelves are located side by side on the upright tube, refer to page 12 for fasteninginstructions.Detail F12513151769Detail E11