Trailer Air Ride Suspension Systems - Transpec
Trailer Air Ride Suspension Systems - Transpec
Trailer Air Ride Suspension Systems - Transpec
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
REYALIGN DETAILSCare must be taken to ensure that the REYALIGN TM option is installed correctly.HARDWARE COMPONENT LIST (per beam)Qty Description Part No.1 Pivot Bolt Q151B22240TF21 Nut Q341B22T13F22 Disc Spring Washers Q419221 Flange Washer C8030571 Pivot Bolt Sleeve C8030581 Plastic Sleeve Cover P8030552 Beam Spacers P8030591 ReyAlign Asy A8030611. Assemble the hardware as shown, ensuringcorrect installation of disc spring washers andensuring that the flange washer is installed onthe opposite side to the alignment assembly.2. To align the suspension, turn the 19 mm(3/4") adjustment shaft found on the front ofthe hanger. This will either pull the beam / axleforward or push it rearward, till you find thecorrect alignment.Beam SpacerP803059ReyAlignAssemblyA803061Flange WasherC803057Pivot BoltQ151B22240TF23. Tighten and torque the hanger clamp bolt to815 Nm (600 ft Ibs) using only a torquewrench. Run nut up very slowly.l4. Optional: Weld along top of “TAB” to securealignment in position.NOTE: By cutting welds carefully, you should be able to realign up to 3 or 4 times with minimal or nocleaning.5. Lastly, torque the 19 mm (3/4") adjustment shaft by turning clockwise to 80 Nm (60 ft Ibs).6. Verify that torque is correct on all fasteners.Hex NutQ341B22T13F2Disc Spring WasherQ41922Pivot Bolt Sleeve – C803058Plastic Sleeve Cover P803055Disc Spring WasherQ4192214