TracVision DIRECTV Mobile Receiver/Controller User's Guide

Using the Remote Control3-2 Programming the Remote Controlto Operate Other ComponentsIn addition to controlling the mobile receiver, youmay be able to operate your TV, VCR, DVD, or AUXcomponents using your TracVision remote control. Toprogram your remote control, follow the steps below.1. Keep the remote control aimed at the IR input (or“eye”) for the component you want to control.For example, if you want to program the remotecontrol to operate the TV, keep the remote aimedat the TV’s IR input.2. Press and hold the remote control’s componentbutton (for example, TV).3. At the same time, press the MUTE button for twoseconds.4. Release both buttons.The component button should light and remainlit. If it doesn’t remain lit, repeat Steps 1 through4 above.54-03765. Repeatedly press the upper part of theCHANNEL (CH) button.6. Continue pressing the CHANNEL(CH) button to step through the codesuntil the component turns off,indicating that you have found theCHcorrect device code. If you accidentally pass a codethat responds or realize you may not have been aimingthe remote control at the component, repeatedly pressthe lower part of the CHANNEL (CH) button to stepbackward through the codes.7. Press the remote control’s PWR button to verifythat you have found the proper code. The correctcode will turn the component on and off.8. Press the component button again to lock in thecode (in this example, the TV button).To operate a component, first press the desiredcomponent button (DVD, VCR, AUX, TV, or SAT).Then use the remote control buttons that apply to thatcomponent. For example, the VOLUME (VOL) andMUTE buttons apply only to a TV; the VCR controlbuttons apply only to a VCR or DVD player.3.9PAGE